Customer Questions and Answers for Trim And Membrane Asm by Ge

Edward, This issue would be caused by a faulty membrane switch and is part number WB36K10588 but has been discontinued by the manufacturer with no suitable replacement available.

Gab, The part number for the piece with numbers is the trim and membrane WB36K10588 which unfortunately has been discontinued by the manufacturer and there is no suitable replacement available.

John R, The manufacturer has discontinued this part and has not made a suitable replacement available.

Killbinkel, This issue would most likely be the membrane switch and would be part number WB36K10588.

Hello Chris, This model does show the F7 fault code as a shorted key. You need to replace the control trim as stated. I'm sorry but this part WB36K10304 has been discontinued by the manufacturer and no satisfactory substitutions have been provided. Thank you for your patience and understanding in this matter.

Rob, Remove the two(2) T-15 Torx screws from the bottom of the control panel. Loosen the two 1/4-in. hex-head screws (1 from each corner) that attach the top of the control panel to the range.Place a protective surface over the cooktop. Pull out the bottom of the control panel, then lift the panel off the range. Place the control panel in the service position. Mark and disconnect the wires and wire harnesses. Remove the 4 Phillips-head screws that attach the control board to the control panel, and disconnect the key pad ribbon from the control board. Reverse the procedure and test the operation of the range.

Hello John. Stuck key pad or transistor failure. May mean relay is turned on. If code cannot be cancelled, replace control.

Eli, The first and most important step, is to remove power to the range, before you start any repair. " BACKGUARD DISASSEMBLY Place a towel or other protective padding on the range top. Remove the (1) T-15 torx mounting screw from each end front. Loosen the (2) 1/4" hex head screws one in each upper corner back side. Gently pull the backguard panel out at the bottom and lift the panel upward. Lower the panel onto the protected range top." Remember to label each connector and wire as you disconnect them from the switches and control board, it will make it a lot easier when you start to put things back together.

Tim, With the touchpad being bubbled then you would need to replace the control trim WB36K10304

Hello Larry. Yes, you will need to replace the membrane assembly WB36K10588 on the unit.