John June 25, 2015 for Model Number 110.87089601 I will be changing the felt seal (AP3790434) because of brown marks on clothing. I should do both of them you think? Also want to replace, while I am in there, the air duct assembly (AP3097246). I was hoping for a video but no luck. Is there anywhere that I could get some kind of guidance in installing it? Thanks, John
1 Answer Hello John. To replace the air duct, you will remove the back access panel and take out the screws securing it. Then pull it out of the cabinet. Read More...
Raymond August 05, 2014 for Model Number gew9868kq1 How do I reinstall the heater box into the back ?does it go over or inside?
Bob May 21, 2014 for Model Number GEQ9800PW1 The vent opening on the air duct (3387911) is rusted. When clothes lay against it they get a rust line on them. Is it possible to paint the vent so there is no rust transfer or must the air duct be replaced? Or maybe just the vent opening be replaced?
Rthomas January 02, 2014 for Model Number Duet Dryer GGW9200LW0 The screen on the air duct assembly has broken in some areas and is catching on my clothes causing small holes. Is it possible to replace just the screen and not the entire assembly? OR do you sell a high temperature plastic spray that I can somehow coat the jagged edges? Otherwise the Dryer works great and I hate to replace.
1 Answer Hello! Unfortunately, parts on the air duct assembly W11168650 are not available separate. Sorry about that! Read More...
Scott September 15, 2013 for Model Number GEW9200LW1 If the dryer part #AP3097246 get's old or rusty doe's it effect the dryer's abilty to dry faster.
Archie July 24, 2012 for Model Number gew9200lwq how do you det the dryer assembly for the heating element back into the dryer
1 Answer Archie, We're sending you some additional information, but installing the heater assembly to the inlet duct, is pretty simple, align the end of the assembly with the inlet duct opening, slip the end into the opening and install and tighten the mounting screws to the mounting bracket. If the inlet duct has been removed, you will need to re mount it to the backside of the rear bulkhead, with the screws, and move on from there. Thanks Read More...
Diane August 08, 2011 for Model Number Whirlpool electic dryer GEQ8811LW1 Does the heat box fit into or over the bottom opening of the Air Duct Assembly? We are having a hard time getting the heat box back in place. Thanks, Diane
1 Answer Hello Diane. The heater box goes into the air duct assembly WP3387911. These can be tight to get back in place. Hope this helps. Read More...