Jason February 15, 2025 for Model Number WDT750SAHZ0 Just for clarification, this the lower spray arm?
1 Answer Hello Jason, thank you for contacting Appliance Parts Pros. [W10837249] is the lower spray arm. Read More...
Larry May 24, 2023 for Model Number KUDE20IXSSA Is there any way I can clean this part without having to replace it?
1 Answer Larry, You can soak the spray arm in vinegar and this should be able to clean the spray arm. Read More...
1 Answer Paul, There is a locking nut under the spray arm. You will rotate this and then you will then lift it off and install the new one. Read More...
Brad May 13, 2023 for Model Number WDF530PAYW4 My spray arm is cracked. Does this mean that it needs to be replaced?
1 Answer Randy, Under this spray arm is a nut that you rotate to take it off and put it back on. Read More...
Garry Parsley September 11, 2020 for Model Number WDF750SAYW2 The lower spray arm is very loose, and if pointing straight front to back, will catch the bottom rack so it cannot be pulled out. I removed the arm, and the locking device has about 3/8" play up and down. Should there be a seal or thrust washer in here somewhere, or is this the way it is designed? Would a new arm correct this problem?
1 Answer Garry, This issue sounds likely that the spray arm would need to be replaced due to the play in the locking nut. Read More...
Karen August 26, 2020 for Model Number WDF750SAYB2 My lower Spray-arm fell off during the wash cycle and unfortunately melted a bit. Will a new one stay on? And How does it lock in place? Thanks
1 Answer Karen, the lower spray arm WPW10491331 has a lock nut on the bottom that would rotate clockwise to secure the spray arm to the cover bracket. Read More...
Randy July 13, 2020 for Model Number wdf590salw arm /spray hits the upper rack during opperation causing a knocking sound,Will replacing the arm spray solve that ?
1 Answer Randy, Either the spray arm is loose or some holes are clogged with debris. Check the nut on the spray arm for tightness. If tight then remove the spray arm by turning the nut the opposite way and remove. Check that all the holes are clear. Use a toothpick if needed to clear the holes and rinse out in the sink. Read More...