Richard May 08, 2019 for Model Number GI15NDXXS0 There is a rubber piece in the drain on water pan WP2324334 (AP6007350). Is this a check valve to prevent the pan from emptying through tube AP6007230 with the hole in the loop? My water runs out of the tube all the time and empties the pan. This is above the drain pump so the pump is not the problem.. Maybe the pump opens the check valve?
1 Answer Richard, you will want to make sure that the drain tube WP2313851 has the loop up so that the hole in the loop is able to stop any siphoning. If that is good, then you will want to inspect the pan WP2324334 for excessive wear or brittleness. If the pan checks good, then the rubber check valve, which is part of the drain pump W11566407, may be worn out and would need to be replaced. Commonly it is the drain tube loop is not set properly and needs to be adjusted. Read More...
Avalon Ice May 10, 2017 for Model Number kitchenaid kuic15prxs3 I went to restart our ice machine after a long off season. The Water Pan housing for the drain pump was cracked and the drain pump had basically fallen out. I was able to remove the old water pan without any problem at all, but I am wondering how the drain pump would be installed into a new water pan. Does it simply snap or twist into place? There weren't any obvious screws or anything... I assume that I can simply get a new pan (and perhaps a couple new, clean tubes while I am at it) but just want to be sure that I can get the old pump into the new tray- always easier to break something down than to get it back up and running. Thank you!
1 Answer Avalon Ice, For this unit the drain pump will just twist in and out of the new drain pan on the unit. Read More...
Da Vid April 24, 2017 for Model Number KUIS18NNTB2 Hello. I was just given an Ice Machine that has a missing part or set of parts. I was told that the pump was removed. Looking at it from the back, it appears that there is a part missing that is to the right of the compressor. There is a copper line coming from valve in the space that is just resting with the fitting near the very back. Above the empty space is a white spout that is coming from the compartment above the empty space. I'm wanting to know what is missing.
1 Answer David, The big open space to the right of the compressor would incorporate a drain pump for if you are not having a gravity feed drain and have to pump the water to a different location. The part number for this pump will be 1901A. Read More...
Robin June 14, 2016 for Model Number Kitchen aide 15" icemaker part no. 2324334 for water pan Can anyone tell me why part no. 2324334 is on indefinite back order. It is the reservoir pan for the kitchen Aden 15" ice machine.
1 Answer Hello Robin. Sorry, we will not have that information. The manufacturer would be the only one who would know the answer. Thank you. Read More...
Steve May 24, 2016 for Model Number KUIS15NRTS1 This pan has two holes in the bottom, one has a cap that screws on. The other hole is where the drain pump connects to pan. Is there a check valve made into the pan to prevent water loss while drain pump is not running. This machine is loosing water through the drain pump during the freeze cycle when the drain pump is not running. Thanks for your help.
1 Answer Hello Steve. I am not seeing a check valve. Either the pan is cracked or the pump is bad and is not sealing good. Read More...
Steve May 24, 2016 Hi, WP pan, part # 2324334. Does the opening for drain pump have a check valve to prevent water loss during freeze cycle, while drain pump is not running ? Thanks for your help,
1 Answer Hello Steve. No, there is a cap on the bottom of the pan that keeps the water in the pan. Read More...
Brent December 16, 2014 for Model Number KUIC15NRTS0 Under the Water Reservoir you have a piece that sits down on the water pump 2313705. Right under the water pan (connect on the water pan) is the tube the comes up and goes towards the back of the icemaker. I do not understand what tube and how the attaches to that male end? Right now when water goes in the pan it just seeps right out that hole. Does part number 2313851 connect to it? I think part 2313851 (J shaped tube) sits in the pan and the long piece hangs out of the back but I do not know if that should then be pushed onto that male end that is made on the water pan (underneath the pan).
1 Answer Hello Brent. The long tube that hangs down under the water pan is the over flow tube. The bottom end does not attach to anything, it allows the water to run down the drain hole. Read More...