Customer Questions and Answers for Range Oven Door Spring by Whirlpool

Hello Matt. The spring attaches to the holes in the hinge 3420A033-34.

Hello Oscar. The spring is almost 6". We will need your model number to help you with this. Please call 1-877-477-7278 or post your model number with a new question on the parts page. Here is a link to help you locate it. http://www.appliancepartspros.com/modelnumber_locator.aspx

Hello Oscar, Since the manufacturer doesn't provide specifications like this, we can only count the one inch squares in the picture of the part on our site. They are one inch squares so it appears to be about 5 3/4 inches in length.

Hello J.W., I can give you a general description but without the model number of your unit, I cannot be specific. Remove the power supplky to the unit to prevent electricution and : 1. Open oven door slightly and grasp door on both sides. 2. Lift up and off the hinge receivers. 3. Reverse procedures to reinstall oven door. You will then need to remove the main top: Maintop Assembly (Smoothtop Models) 1. Turn power off. 2. Open oven door and remove screws securing maintop to oven chassis, located on the outside edges of the maintop. 3. Raise the front edge of the maintop and pull forward approximately 6 inches. 4. Label and disconnect wire terminal plugs from the maintop assembly. 5. Lift maintop assembly from the oven chassis. 6. Reverse procedures to reinstall maintop assembly. OR Maintop Assembly (Coil Element Models) 1. Turn power off. 2. Open oven door and remove screws securing maintop to oven chassis, located on the outside edges of the maintop. 3. Move the top assembly down, then slightly up and toward the front to unhook the back edge from the backguard. 4. Label and disconnect wire terminal plugs from the maintop assembly. 5. Lift maintop assembly from the oven chassis. 6. Reverse procedures to reinstall maintop assembly. You will now need to remove the side panels: Remove screws securing lower rear galvanized cover from unit. Remove screws securing top and back of side panel. Pull rear of side panel away from range then slide side panel forward to release from side panel spacers. You will now need to remove the storage drawer: Pull drawer straight out to first stop. Lift the front and pull out to second stop. Let front of door rest on floor. Place hands toward back of drawer and lift it out. Remove the top and bottom screws securing oven door hinge to the front frame. Remove oven door hinge from oven chassis. Reverse procedures to reinstall.

Hello AK. You will check and see if the spring or the hinge is broken on the unit. You may have to disassemble to see the broke part.

Hello Jay. There is no service manual for this model. You will need to remove the side panels of the range to replace the door springs WP7803P058-60. Hope this helps.