Amana Washer AA7231 Pumps but will not spin

This agitate & spin drive belt transfers motor power to the washer's transmission and spin mechanism. Replacing a worn belt restores proper agitation and spin performance and helps prevent slipping noise or burning-rubber smells.

• Links the drive motor to the main pulleys to power both agitation and spin
• Replaces a broken, stretched, or glazed belt that slips under load
• Common symptoms: no spin or no agitation, weak/slow spin, squealing, burning-rubber odor, visible cracks or fraying
• Helps ensure smooth, consistent tub movement and complete cycles

• Disconnect power and water; wear cut-resistant gloves
• Access the belt from the bottom or rear, per your model's service procedure
• Release belt tension (motor carriage/idler), remove the old belt, and route the new belt around the motor and drive pulleys as shown on the unit
• Rotate by hand before restoring power and running a test cycle

The Thrust Washer is an OEM part for Whirlpool washers and dryers, reduces friction between moving parts within the appliance. This small component is placed between rotating surfaces to ensure smooth operation and to extend the lifespan of those parts. The thrust washer can wear down or become damaged due to the constant pressure and movement.

Causes for replacement may include normal wear and tear, overloading the appliance, which puts extra stress on mechanical components, or a lack of regular maintenance.  

Symptoms of a bad Thrust Washer include:

• Increased noise during operation
• The appliance vibrating more than usual
• A decrease in performance efficiency

This genuine Whirlpool OEM replacement part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Retaining Ring is an OEM replacement part for Whirlpool dryers and washing machines. This retaining ring holds the rear wheels on the axels of the washer or dryer. 

Symptoms of a bad retaining ring can include wear and tear over time, damage due to accident or impact, or corrosion affecting the structural integrity.

Causes of a bad retaining ring dryer include:

• Excessive vibration or movement of the drum during operation 
• Noise or banging sounds from loose components   
• Deformation or cracking of the retaining ring itself
• The dryer door not closing properly

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.