Bosch Dishwasher SHE55RF5UC/68 Noisy

The Drain Pump is an OEM replacement part for Bosch dishwashers. It is responsible for pumping out dirty water from the dishwasher tub at the end of each cycle. The drain pump works to thoroughly empty the tub in a timely manner to facilitate a smooth transition to the next cycle.  

Causes of a bad drain pump can include a clogged impeller or blockage of debris inside the pump housing that inhibits proper water flow. 

Symptoms of a bad drain pump include:

• Incomplete draining of water at the end of cycles 
• Water remaining or pooling at the bottom of the tub
• Loud grinding or clicking noises emanating from the pump area
• Cycles failing to advance or resume properly

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore dishwashers.

Note: Due to a factory design change, connector part# 00623143 may also be needed.

The Circulation Pump Assembly is an OEM component specifically designed for Bosch dishwashers. It is responsible for circulating water during the wash cycle and helping dishes get properly cleaned. 

Causes of a bad circulation pump assembly can include normal wear and tear, as well as damage from debris getting caught in the pump mechanism over time. 

Symptoms of a bad circulation pump assembly include:

• Inability to circulate water, resulting in poor wash performance  
• Loud noises or vibrations coming from the pump area
• Leaks around or below the pump housing

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore dishwashers. Replace yours today to restore optimal water circulation for thorough yet gentle cleaning.
 

The Water Inlet Valve is an OEM part for Bosch dishwashers. This component is responsible for controlling the flow of water into the dishwasher. It operates via electrical signals from the dishwasher's control board, opening to allow water to enter during the fill cycle and closing to prevent water from entering during other cycles. 

Causes of a bad Water Inlet Valve include mineral deposits from hard water, which can block the valve and restrict water flow, or electrical failure, which prevents the valve from opening or closing properly. 

Symptoms of a bad Water Inlet Valve include:

• Dishwasher not filling with water, leading to unwashed dishes.
• Water leaking from the dishwasher, potentially caused by a valve that doesn't close completely.
• Overfilling of the dishwasher, which can occur if the valve fails to shut off.

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.