Frigidaire Washer FTF5000HS0 Pumps but will not spin

The Drive Belt is an OEM part for Frigidaire washing machines. This part transfers the rotational force from the motor to the drum, enabling the tumbling action during wash cycles.

Causes of a bad Drive Belt include wear and tear over time, exposure to excessive heat or moisture, or physical damage from improper installation or foreign objects.

Symptoms of a faulty Drive Belt include:

• Loud squeaking or grinding noises during the wash cycle
• The drum not spinning or rotating properly
• Slipping or failure to agitate during wash cycles
• Excessive vibrations or shaking from the washer

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

This is a motor control board for a washing machine. It comes with the board, tape, bracket, and screw mounted on control. In most cases, this part is located on the bottom of the appliance near the drive motor. The purpose is to control the speed of the drive motor. It also works to determine the direction of the tumble and spin actions while a cycle is in process. If the washing machine is pumping but does not spin, this is often the result of a malfunctioning motor control board.If the motor control board has gone bad, it should be replaced. To replace it, make sure the washer is unplugged or the circuit breaker has been turned off. Pull the washer away from the wall, remove the knobs from the front and screws from the back, and lift the control panel. This offers access to the motor control board, which should be removed so the new part can be installed.This motor control board is made for use with washing machines by Electrolux, Frigidaire, Crosley, and Kenmore. It is sold on an individual basis. This is an authentic OEM replacement part that is directly sourced from the manufacturer.