General Electric Washer WWC7500FBL Leaking

By GE. Fits many different washer brands and models. Includes insert.

This hose clamp kit secures the washer's hoses at the pump, tub, or valve connections, helping stop leaks and hose blow-offs. Replace worn or missing clamps to restore a tight, reliable seal during fill, wash, and drain.

• Secures drain, pump, and fill hoses to fittings to maintain a watertight seal
• Helps prevent drips, leaks, and hoses slipping off during vibration
• Replaces clamps that are rusted, stripped, deformed, or missing
• Common symptoms: water leaking at hose joints, loose hose connections, clamp won't tighten
• Useful when installing a new hose, pump, or valve

• Unplug the washer and turn off water supplies; have towels or a pan ready for residual water
• Release and remove old clamps; seat the hose fully over the fitting before installing new clamps
• Tighten evenly and do not overtighten to avoid hose or fitting damage
• Restore power and water, then run a short cycle to check for leaks at each connection

This door gasket seals the refrigerator door to keep cold air in and warm air out, helping maintain proper temperatures and reduce energy use. It replaces a worn, torn, or deformed seal to restore a tight door closure. What it does:

• Creates an airtight seal around the refrigerator door edge to preserve internal temperature.
• Helps prevent frost buildup and condensation by stopping warm, moist air from entering.
• Reduces compressor run time and energy waste caused by a leaking door.
• Restores proper door alignment and magnetic closure when the original gasket is damaged.

• One replacement refrigerator door gasket

• Disconnect power to the appliance before starting any work.
• Clean and dry the door flange thoroughly before fitting the new gasket.
• Start at one corner, press gasket firmly into the channel, and ensure magnetic/retention edges seat evenly around the door.
• If gasket wrinkles or does not seat, warm it slightly or allow time for it to relax; avoid sharp tools that can damage the new seal.

Fits GE/Hotpoint washers.