Lg Dishwasher LDF7811ST-01 Leaking

The Water Inlet Valve is an OEM part for LG dishwashers. This part regulates the flow of water into the dishwasher tub during the fill cycle, ensuring the proper water level for effective cleaning.

Causes of a bad part can include sediment or mineral buildup obstructing the valve, physical damage from water pressure or impact, or electrical malfunctions preventing the valve from opening and closing correctly.

Symptoms of a bad Water Inlet Valve include:

• Failure of the dishwasher to fill with water
• Overfilling or insufficient water levels in the tub
• Leaks from the valve or water inlet area
• Error codes or indicator lights related to water supply issues

This OEM LG part is also compatible with some Kenmore models.

The Door Gasket is an OEM part for LG dishwashers. It forms a watertight seal around the dishwasher door, preventing leaks during the wash cycle. This gasket ensures that water stays inside the dishwasher, promoting efficient cleaning and protecting your kitchen from water damage.

Causes of a bad door gasket can include regular wear and tear, buildup of detergent residue, or damage from closing the door on obstructive items. Over time, the gasket can become brittle or cracked, compromising its sealing capabilities.

Symptoms of a bad door gasket include:

• Water leaking from the dishwasher door
• Visible cracks, tears, or deformities in the gasket
• The dishwasher door not closing properly
• Increased moisture or puddles around the base of the dishwasher

This OEM LG part is also compatible with Sears/Kenmore models.

This dishwasher sump gasket seals the joint between the sump assembly and the tub to prevent leaks and maintain wash performance. Replace it if the old seal is worn, flattened, cracked, or damaged to stop water escaping beneath the unit.

• Creates a watertight seal where the sump attaches to the tub
• Helps prevent water leaks from the base of the dishwasher
• Supports proper circulation and overall wash performance
• Common failure signs: puddles under the unit, leaks during a cycle, or a visibly torn/deformed gasket

• Disconnect power and turn off the water supply before servicing
• Access the sump from inside the tub (remove lower rack, spray arm, filters, and sump cover) or from below, depending on model
• Clean mating surfaces; install the new gasket evenly without twists or gaps
• Reassemble and run a short cycle to check for leaks