Lg Washer WM2016CW/00 won't spin or doesn't spin

This washer rotor assembly mounts on the direct-drive motor and works with the stator to turn the basket. Replacing a worn rotor restores smooth tumbling and full spin performance when the drum won't turn or makes harsh scraping noises.

• Works with the stator to create the magnetic drive that spins the wash basket
• Helps when the washer won't spin or tumble, or only reaches a weak/erratic spin
• Can reduce grinding/scraping noises from the rear of the tub
• Addresses slippage from worn splines or a damaged magnet ring on the rotor

• Disconnect power and turn off water before servicing
• Access the rotor at the back of the tub; remove the rear cover if present
• Support the rotor, remove the center bolt, and pull the rotor straight off; magnets are strong
• Align splines, seat the new rotor fully, start the bolt by hand, and tighten to the manufacturer's specification

Stator assembly for the washer's direct-drive motor that produces the magnetic field to turn the rotor and drive wash cycles. Replacing a worn or damaged stator can restore proper spin and agitation.

• What it does: stationary coil pack inside the direct-drive motor that creates the magnetic field used to rotate the rotor and power wash/spin functions.
• Common symptoms: washer won't spin or agitate, motor hums but won't start, intermittent motor operation, or motor-related error codes.
• Compatibility note: used as the motor stator in applicable LG direct-drive washers.
• Service tip: inspect the rotor and motor connectors for damage when replacing the stator.

• Always disconnect power to the appliance before starting any repair.
• Replacement typically requires access to the motor assembly and separation of the rotor from the stator; handle strong magnets and fragile windings carefully.
• Check wiring harnesses and connector pins for corrosion or damage and ensure all connectors are fully seated during reassembly.

The Tub Bearing is an OEM replacement part for LG washing machines. This component is essential for the smooth rotation of the washer drum, reducing friction and ensuring quiet, efficient operation during wash and spin cycles.

Causes of a bad tub bearing can include wear and tear from regular use, exposure to water and detergent, or overloading the washing machine. Over time, the bearing can degrade, leading to increased friction and noise.

Symptoms of a bad tub bearing include:

• Loud noises during the spin cycle, such as grinding or roaring
• The drum wobbling or moving excessively
• Water leaking from the bottom of the washer
• Poor washing performance or the drum not spinning properly

This OEM LG part is also compatible with Sears/Kenmore models.

The Washer Door Lock Switch is an OEM part for LG washing machines. This critical safety feature locks the washer door during operation to prevent it from being opened, which ensures safety and proper functioning. The door lock switch also communicates with the washer's control system to indicate that the door is securely closed and the machine can begin its cycle.

Symptoms of a bad Washer Door Lock Switch include:

• The washing machine refusing to start, despite the door appearing to be closed.
• The door failing to lock properly, or the lock releasing prematurely during a cycle.
• Error messages on the washer's display related to door closure issues.

Causes of a bad door lock switch can include mechanical failures such as worn or damaged locking mechanisms, electrical issues like faulty wiring or failed solenoids, or alignment problems that prevent the door from engaging the switch properly.

This OEM LG part is also compatible with Sears/Kenmore models.