Lg Washer WM3360HVCA won't spin or doesn't spin

The Rotor Assembly is an OEM part for LG washing machines. This component is critical for the proper functioning of the washer's motor, helping to rotate the drum during the wash and spin cycles. It works in conjunction with the stator to generate the necessary magnetic fields for drum rotation.

Causes of a bad rotor assembly can include excessive wear over time, exposure to heavy loads, or physical damage due to mishandling. A malfunctioning rotor assembly can hinder the washer’s ability to spin and agitate effectively.

Symptoms of a bad rotor assembly include:

• The drum not spinning or agitating properly
• Unusual noises such as grinding or clunking during operation
• Error codes related to motor issues displayed on the control panel
• The washer not completing wash cycles correctly

This OEM LG part is also compatible with Sears/Kenmore models.

This washer motor stator assembly is the stationary windings of the direct-drive motor. Replacing a weak or shorted stator restores smooth drum tumbling and strong, consistent spin performance so wash cycles complete properly.

• Creates the rotating magnetic field that drives the rotor and spins the inner basket
• Works with the rotor to provide torque for wash/tumble and high-speed spin
• Common symptoms: drum won't spin or tumble, stops under load, or motor hums without turning
• Burnt odor or visible heat damage on windings can indicate stator failure

• Disconnect power and turn off water; access the motor from the rear panel
• Remove the rotor center bolt and slide off the rotor; strong magnets—handle carefully
• Unbolt and remove the stator; transfer/reconnect the motor position (Hall) sensor and harness if present
• Tighten fasteners evenly; verify drum rotates freely by hand before restoring power

The Washer Door Lock Switch is an OEM part for LG washing machines. This critical safety feature locks the washer door during operation to prevent it from being opened, which ensures safety and proper functioning. The door lock switch also communicates with the washer's control system to indicate that the door is securely closed and the machine can begin its cycle.

Symptoms of a bad Washer Door Lock Switch include:

• The washing machine refusing to start, despite the door appearing to be closed.
• The door failing to lock properly, or the lock releasing prematurely during a cycle.
• Error messages on the washer's display related to door closure issues.

Causes of a bad door lock switch can include mechanical failures such as worn or damaged locking mechanisms, electrical issues like faulty wiring or failed solenoids, or alignment problems that prevent the door from engaging the switch properly.

This OEM LG part is also compatible with Sears/Kenmore models.