Maytag Dishwasher MDBTT79AWS Door won't close

The Door Latch Assembly is an OEM replacement part for Whirlpool dishwashers. It is responsible for securely latching and locking the dishwasher door during operation, preventing leaks and ensuring a proper seal.

Symptoms of needing to replace the door latch assembly include:

• Difficulty in properly closing or latching the dishwasher door
• Leaks or water seeping out from around the door area
• Visible signs of wear, damage, or cracks on the latch mechanism
• The door not staying securely closed during operation

Causes of a faulty dishwasher door latch assembly can include normal wear and tear over time, physical damage due to impact or mishandling, or issues with the latch mechanism itself.

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore dishwasher models.

The Door Latch is an OEM part for Whirlpool dishwashers. It secures the dishwasher door during operation, ensuring it stays closed and maintains a tight seal to prevent water leaks. This latch also activates the safety switch, allowing the dishwasher to start its cycle only when the door is properly latched.

You should replace this door latch if it becomes worn out, damaged, or fails to secure the door properly. Common causes of a bad latch include repeated use, physical damage from forceful closing, or misalignment of the latch components.

Symptoms of a bad door latch include:

• Dishwasher door not staying closed
• Dishwasher not starting or stopping mid-cycle
• Water leaking from the door during operation
• Difficulty in latching or unlatching the door

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Note: This is the latch only and does not include the handle. For the latch with handle, order part# WPW10130695 which includes a black handle. The factory only offers the latch handle assembly in black. No other colors are available.

This dishwasher door strike mounts to the tub opening and provides the catch point for the door latch. Replacing a worn or bent strike restores positive latching so the control can sense a closed door and run cycles reliably.

• Provides the catch the door latch locks onto
• Engages the door switch so the dishwasher can start
• Helps keep the door securely closed during operation
• Common symptoms: door won't latch or pops open; unit won't start unless pressure is applied to the door; strike is visibly bent, worn, or missing

• Disconnect power at the breaker; turn off water if you need to move the appliance
• Open the door to access the strike at the tub opening; remove mounting screws, replace the strike, and tighten securely
• Save and reuse the original mounting screws
• After installation, check latch engagement and adjust appliance leveling or alignment if needed