Maytag Washer Dryer Combo LSE9900AEE Will not stop filling with water or doesn't stop filling with water

The Hose Clamp is an OEM part for Whirlpool appliances. It secures hoses in place, ensuring a tight connection and preventing leaks in various systems such as washing machines, dishwashers, and refrigerators. This clamp is crucial for maintaining the integrity of the water or air lines it secures.

Causes of a bad hose clamp include wear and tear over time, exposure to water and detergents, or mechanical stress from repeated tightening and loosening.

Symptoms of a bad hose clamp include:

• Leaks at the hose connection points
• Hoses slipping off the connections
• Visible rust or damage on the clamp
• Reduced appliance efficiency due to leaks

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This digital water level switch senses tub water height and tells the washer control when to stop filling, helping the machine use the correct water amount each cycle. It restores proper fill control and water-level signals to the control board. What it does:

• Detects and reports water level to the washer control so cycles advance correctly
• Stops water fill when the proper level is reached to prevent overfilling
• A failed switch can cause underfilling, overfilling, filling errors, or stalled cycles
• Works with the washer's pressure/air system to translate tub water height into an electrical signal

• One water level switch (digital)

• Always disconnect power to the appliance before starting service
• Access typically requires removing the control console or top panel; keep track of fasteners
• Handle the small pressure/air hose and electrical connector gently to avoid damage
• Verify the part number for routing and connector orientation