Maytag Washer Dryer Combo LSG7806AAE Timer will not advance

This Dryer Cycling Thermostat is an OEM replacement part for Whirlpool dryers. It monitors internal temperatures and cycles power to the heating element accordingly. The thermostat ensures the drying air reaches and maintains the optimal heat level selected for fast, effective drying results.

Symptoms of a bad cycling thermostat include:

• The dryer not heating or heating inconsistently  
• Frequent trips of the circuit breaker
• Slower than normal drying times
• Burned clothes due to overheating

Causes of failure may be related to normal wear over time, dust buildup affecting sensor readings, or incorrect thermostat calibration. 

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

The Dryer Gas Valve Coil Kit is an OEM replacement part for Whirlpool dryers, as well as Kenmore and Samsung dryers. It is a set of coils that control the flow of gas fuel to the burner. The gas valve regulates the precise amount of gas needed to properly combust and generate heat for drying clothes. 

Causes of a bad gas valve coil can be wear and tear from regular use, lime or mineral buildup on the coils over time, or physical damage to the coils.

Symptoms of a bad gas valve coil kit include:

• Inconsistent or incomplete drying  
• Slow or intermittent drying
• Burning smell from the gas dryer
• Improper burner ignition or non-ignition

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This mechanical washer timer controls the sequence and duration of wash, rinse, and spin cycles. Replacing a worn timer restores proper cycle advancement and consistent operation when the washer stalls, skips steps, or only progresses when the knob is turned.

• Controls and sequences power to the drive motor, water inlet valves, and drain pump per the selected cycle
• Advances the machine through fill, agitate, drain, rinse, and spin intervals
• Provides internal contacts that start/stop each step and signal the next stage
• Common symptoms: no cycle advance, stopping mid-cycle, intermittent operation, or advancing only when manually turned

• Disconnect power before servicing; do not work on a live appliance
• Access the control console; remove the panel/cover to reach the timer
• Photograph and transfer wires one at a time to matching terminals to avoid miswiring
• Mount the new timer securely and align the shaft with the knob/dial before reassembly