Samsung Dishwasher DB5710DT Leaking

This dishwasher door seal fits into the tub channel to create a tight, water-resistant barrier when the door closes. Replacing a worn gasket helps stop nuisance leaks and restores proper door compression and moisture containment.

• Creates the primary seal around the dishwasher tub opening when the door is closed
• Helps keep wash water, suds, and steam inside the wash cavity
• Wear can lead to drips at the front corners or along the sides
• Replace if the gasket is cracked, torn, flattened, or no longer sealing; the door may be harder to latch

• Disconnect power and turn off the water supply before servicing
• Remove the old gasket and thoroughly clean the channel of debris and residue
• Warm and relax the new gasket; start at the top center and press evenly into the channel without stretching
• Close the door for several hours to help the seal set; run a test cycle and check for leaks

Located on the supply tube behind the upper dishwasher rack.

This Tub Edge Trim (bottom) fits along the lower edge of the dishwasher tub opening. Replacing a cracked, warped, or missing trim restores a clean finished edge and helps the door open and close smoothly without rubbing or snagging.

• Finishes and protects the bottom lip of the tub opening
• Helps maintain proper clearance for the door panel and gasket
• Replaces damaged, warped, discolored, or missing trim
• Typical symptoms: loose or broken strip, rubbing when closing, visible gap along the lower edge

• Disconnect power to the dishwasher before servicing
• Open the door and remove the old trim by releasing its retaining tabs or screws; note orientation
• Align the new trim on the lower tub edge and press or fasten until fully seated across the opening
• Verify the door closes freely and the gasket seats evenly before restoring power

No longer includes course threaded sleeve. When replacing upgrade to new motor. For new motor, order from parts list by model number.

Replacement pump gasket with silicone sealing material that restores a watertight seal between the pump and housing. Helps stop leaks at the pump area and prevents water pooling under the appliance.

• Seals the pump to the housing to help prevent water leaks and drips.
• Common repair for visible water under the appliance or leaks coming from the pump area.
• Silicone sealing material provides a flexible, water-tight interface that conforms to the pump housing.
• Designed to replace the factory pump gasket for a direct fit and proper sealing.

• Disconnect power and water supply before beginning any repair.
• Remove the pump assembly to access and replace the gasket.
• Clean and dry mating surfaces before installing the new gasket; seat evenly to ensure a full seal.