Samsung Washer WF316BAC Leaking

The Hose Clamp is an OEM part for Whirlpool appliances. It secures hoses in place, ensuring a tight connection and preventing leaks in various systems such as washing machines, dishwashers, and refrigerators. This clamp is crucial for maintaining the integrity of the water or air lines it secures.

Causes of a bad hose clamp include wear and tear over time, exposure to water and detergents, or mechanical stress from repeated tightening and loosening.

Symptoms of a bad hose clamp include:

• Leaks at the hose connection points
• Hoses slipping off the connections
• Visible rust or damage on the clamp
• Reduced appliance efficiency due to leaks

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Hose Clamp is an OEM part for Whirlpool washing machines. This clamp secures the hose in place, ensuring a tight connection and preventing leaks during operation. It is essential for maintaining the integrity of the washing machine's water system, securing hoses that carry water to and from the washer.

Common causes of a bad hose clamp include rust, physical damage, or loosening from repeated tightening and loosening.

Symptoms of a bad hose clamp include:

• Water leaks around the hose connection points
• The hose slipping off the fitting
• Visible rust or wear on the clamp
• Difficulty in tightening the clamp to secure the hose

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and some Kenmore models.

This flexible door boot seal lines the washer's door opening and seals the gap between the tub and front panel, helping keep wash water contained and preventing leaks from the front of the machine.

• Creates a watertight seal between the outer tub and front panel/door opening
• Helps prevent leaks during fill, wash, and spin cycles
• Flexible design maintains the seal as the door opens and closes
• Common failure signs: water on the floor near the door, drips from the front, visible rips/cracks, or a loose/deformed gasket; persistent mildew buildup around the boot

• Disconnect power and turn off water before servicing
• Remove the front/door panel as needed, then release the outer and inner retaining bands to remove the old boot
• Note orientation marks and any hose/port locations; seat the new boot evenly all the way around before refitting clamps
• After reassembly, run a short fill/rinse and check the door area for leaks

This assembly is the housing the dispenser drawer slides into, restoring a smooth pull-out action and proper dispensing. It supports the drawer and channels water through the detergent, bleach, and fabric softener compartments into the tub.

• Holds and guides the pull-out dispenser drawer
• Routes incoming water through the dispenser cups into the washer
• Helps seal the dispenser opening to minimize drips and leaks
• Common symptoms: leaks at the dispenser, poor detergent/softener dispensing, or a drawer that sticks, jams, or won't seat

• Disconnect power and shut off water before servicing
• Remove the dispenser drawer; remove top/console panels as needed for access
• Detach fill hose(s) and outlet chute; transfer any seals, clips, and fittings to the new housing
• Reassemble and run a short fill/rinse to check for leaks