Dryer Ptc Parts

This switch-plg is the OEM replacement plug switch that completes or interrupts the appliance's power connection, restoring reliable on/off control for the affected circuit. It fits where the original plug-style switch was used. What it does:

• Opens and closes the electrical circuit to allow or stop power flow through the plug-style connection
• Restores on/off control when a worn or failed plug switch causes intermittent power or a unit that won't power on
• Provides the same basic mechanical/electrical function as the original switch in the appliance's plug assembly
• Works as a direct replacement for the factory-installed switch-plg part

• Disconnect power (unplug appliance or shut off breaker) before removing or installing this switch
• Handle terminals carefully; secure terminal connections during replacement
• Compare the new part to the old part for correct orientation and fit before final assembly

A push-button signal switch that completes the user input circuit to the control board so selections register and the appliance responds to commands. Replaces a worn or unresponsive front-panel switch to restore reliable button operation. What it does:

• Sends the user's button press signal to the control board so commands are recognized
• Commonly replaced when front-panel buttons are unresponsive or intermittently work
• Helps restore proper cycle selection and control responsiveness
• Works as the user-input contact in the control/display assembly

• Disconnect power before starting repair to avoid shock or injury.
• Access the control panel per your model's service instructions; handle the display and wiring gently.
• Verify connector orientation and secure all harness connections before reassembling.
• Test operation after reassembly to confirm the new switch functions correctly.

This door release cable connects the dryer door latch to the release mechanism so the door opens and closes reliably. Replaces a worn or broken cable to restore normal door operation and improve safety. What it does:

• Transfers motion from the door handle to the latch so the door can be opened and closed
• Helps ensure the door stays securely closed during operation
• Commonly replaced when the door won't latch or handle feels loose
• Prevents intermittent door-release failures that can stop dryer cycles

• Disconnect power before beginning any repair to avoid shock or injury
• Inspect the latch, handle, and routing path and replace any damaged clips or fasteners
• Basic hand tools typically required; follow OEM instructions for routing and attachment

This flame sensor wire is the replacement lead that connects the oven/range flame sensor to the control system, restoring reliable flame detection for safe burner operation and proper ignition control. What it does:

• Carries the sensor signal from the flame sensor to the control board so the system can detect a sustained flame
• Helps prevent repeated ignition attempts or control lockouts caused by an open or damaged lead
• Common symptom: oven or range fails to detect flame or cycles continuously during ignition
• Used where a separate sensor lead is required to maintain correct sensing and safety operation

• Disconnect power and shut off gas before servicing; follow all local codes and safety procedures
• Handle the sensor lead and connectors gently to avoid damage; ensure secure, corrosion-free connections
• Route the lead away from direct burner contact and high-heat paths to prevent premature failure