Dryer Ptc Parts

This flame sensor wire is the replacement lead that connects the oven/range flame sensor to the control system, restoring reliable flame detection for safe burner operation and proper ignition control. What it does:

• Carries the sensor signal from the flame sensor to the control board so the system can detect a sustained flame
• Helps prevent repeated ignition attempts or control lockouts caused by an open or damaged lead
• Common symptom: oven or range fails to detect flame or cycles continuously during ignition
• Used where a separate sensor lead is required to maintain correct sensing and safety operation

• Disconnect power and shut off gas before servicing; follow all local codes and safety procedures
• Handle the sensor lead and connectors gently to avoid damage; ensure secure, corrosion-free connections
• Route the lead away from direct burner contact and high-heat paths to prevent premature failure

This genuine electrical harness connects the washer's FSD/PSH control circuit to the main wiring, restoring reliable power and signal routing for normal cycle operation. Replaces a damaged or worn harness to help resolve intermittent power or control faults. What it does

• Routes power and control signals between the washer control assembly and safety/pressure switches.
• Helps restore operation when worn, burnt, or broken wires cause intermittent starts or unresponsive cycles.
• Stops arcing or shorts caused by frayed conductors that can trip breakers or blow fuses.
• Maintains correct connector fit and routing to prevent pin damage and poor contacts.

• One complete electrical wiring harness as shown.

• Disconnect power at the breaker or unplug the appliance before beginning work.
• Handle connectors by the bodies, not the wires; match connector shapes and colors during installation.
• Route and secure the harness to original clips and fasteners to avoid chafing or heat exposure.

This electrical harness is the main wiring assembly that routes power and signals between a fridge's control board and internal components, restoring proper electrical connections for reliable operation. What it does

• Connects the control board to components like lights, fans, sensors, and defrost/heater circuits
• Replaces damaged or corroded wiring that can cause intermittent function or component failures
• Helps resolve symptoms such as no lights, fans not running, intermittent cooling, or error codes related to open/shorted circuits
• Provides factory-style plug connections to maintain correct electrical routing and polarity

• One complete electrical/main wiring harness

• Always disconnect power before servicing electrical components to avoid shock
• Inspect connector pins and wiring for damage; replace harness if any connectors are broken or wires are burnt
• Route harness following existing clips and channels; avoid contact with sharp edges or moving parts