Trash Compactor K-Cup Pad Post Pin Cogged Parts

This replacement stud is a factory-specified piece of hardware used to secure components in your appliance. Replacing a worn, stripped, or missing stud restores a solid fit to help reduce looseness and vibration. What it does:

• Provides a mounting point to fasten specified parts or panels
• Helps keep components aligned and secure during operation
• Replaces damaged, corroded, or missing original hardware
• Can resolve symptoms like loose parts, rattling, or misalignment where this fastener is used

• 1 stud

• Disconnect power; shut off water and/or gas supply if applicable
• Access the mounting location per your model's service information
• Start threads by hand to avoid cross-threading; tighten only until snug
• Reuse any original washers, clips, or nuts if required and in good condition

This slotted spring pin is a small retaining fastener that secures shafts, levers, and small assemblies so moving parts stay aligned and engaged. It restores proper mechanical retention in controls and linkages. What it does:

• Holds shafts, levers, and linkage components in place to prevent unintended movement or disengagement
• Keeps control knobs, actuator arms, and small rotating parts secured under normal operation
• Commonly replaced when the original pin is worn, bent, broken, or missing
• Helps eliminate symptoms like loose or disconnected knobs, slipping linkages, or intermittent mechanical engagement

• One spring slotted pin (single)

• Disconnect power (and water if applicable) to the appliance before servicing
• Remove the damaged pin and install the replacement using appropriate pliers or a pin punch; do not force metal parts
• Verify correct orientation and full engagement of the pin in the retaining hole before reassembling
• If the pin is difficult to seat, inspect mating parts for wear or distortion and replace any damaged components

This adhesive insulation is a thin, self-stick insulating strip that helps reduce heat transfer and dampen vibration where applied. It restores proper insulation and can improve efficiency and condensation control in affected areas. What it does:

• Provides a thermal barrier to help reduce heat transfer between components or panels
• Dampens vibration and minimizes noise from rubbing or contact points
• Helps reduce condensation by insulating cold surfaces from warmer air
• Keeps gaps sealed where insulation has deteriorated or fallen away

• Disconnect power before accessing appliance panels or internal areas
• Remove old insulation and thoroughly clean and dry the mounting surface for best adhesion
• Align the strip and press firmly to ensure full contact; trim if necessary to fit
• Use caution around sharp edges and wiring