30-3979-23/02 Parts

Replacement manifold panel cover that mounts over your gas range manifold. Restores the finished surface for controls when the original is cracked or damaged.

This right-side end cap is a replacement trim piece that secures and finishes the outer edge of the appliance door/frame, restoring appearance and helping keep the door components aligned for smooth operation. What it does:

• Covers and protects the outer edge of the door/frame and internal components from dirt and damage
• Holds adjacent trim and seals in proper position to reduce gaps and rubbing
• Restores factory appearance where a cracked or missing end cap left an exposed edge
• Helps prevent minor snagging when opening or closing the door

• Disconnect power to the appliance before starting any repair
• Removal/installation typically requires light prying or removing a few trim screws; use non-marring tools to avoid damage
• Align tabs or slots and press/secure the cap until it snaps into place; verify even fit along the edge
• If sealing or alignment issues persist after installation, check adjacent trim and fasteners for wear or damage

Secures oven door glass panels in place. Replace if the retainer wire is bent, broken, or missing to prevent loose or rattling door glass during use.

Shaft bushing for ranges. Installs on moving shafts to reduce friction and provide smooth operation. Replace if worn, cracked, or missing.

Decorative bezel ring that fits around your range's burner control knob. Replace if cracked, discolored, or missing to restore a clean appearance.

Replace cracked, broken, or missing inner oven door glass for your gas range. This transparent glass panel installs in the door assembly to restore visibility.

Replace your range door gasket seal to maintain proper heat retention and cooking efficiency. Install when you notice heat escaping or uneven cooking.

Secures components inside your range. Replace if the original nut is stripped, corroded, missing, or no longer holding parts firmly in place.