Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
The Lower Door Seal is an OEM replacement part for Whirlpool dishwashers. This seal runs along the bottom edge of the dishwasher door, creating a tight seal against the tub when closed to contain water inside during cycles. This seal measures approximately 22 inches in length
Causes of lower door seal failure commonly involve repeated compression stresses from opening/closing actions gradually stiffening the flexible gasket material. Drying out and cracking occurs over years of heat exposure as well.
Symptoms of a worn lower door seal include:
This versatile OEM part is also compatible with select Maytag, KitchenAid, Jenn-Air, Amana, and some Kenmore dishwasher models.
My Whirlpool dishwasher was leaking out the bottom of the door. I replaced the gasket and the lower door seal. When I ran a test wash, it was still leaking. After reading more online, I found that it could be a cracked washer arm. The initial inspection of the washer arm looked normal but when I used my faucet to slowly pour water into the inlet of the arm, I noted that water was leaking through a seam and not just the holes where it should come out. I then tried running a wash without the... Read more
Usually ships within 4 - 14 days
The Diverter Motor is an OEM part for Whirlpool dishwashers controls the diverter valve, which directs water flow to various spray arms throughout the dishwasher during a wash cycle. By accurately adjusting the flow of water, the diverter motor ensures that dishes are thoroughly cleaned and rinsed by optimizing coverage and water intensity according to the cycle selected.
Causes of a bad Diverter Motor can include electrical failures, mechanical wear over time, or damage from water infiltration.
Symptoms of a bad Diverter Motor include:
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
ORDERED NEW SUMP AND DIVERTER MOTOR, THE SHAFT ON THE DIVERTER MOTOR FELT A LITTLE ROUGH SO I WENT AHEAD AND REPLACED IT, THE SUMP REPLACEMENT WENT FAIRLY EASY. HAD TO MAKE A TRIP TO THE HARDWARE STORE FOR A HOSE CLAMP. ONE HOSE ON THE SUMP HAS A CLAMP THAT IS NOT REUSEABLE. YOU SHOULD ALSO ORDER THIS CLAMP. IT IS NARROW AND A REGULAR HOSE CLAMP WILL NOT WORK. Read more