71949163402 Parts

This spin speed knob lets you select wash spin settings so you can adjust water extraction for different loads. It replaces a worn, cracked, or loose dial to restore clear speed selection and smooth control. What it does:

• Selects the washer's spin speed setting for proper water extraction
• Restores firm, accurate dial operation when original knob is loose or broken
• Helps prevent accidental speed changes during a cycle
• Matches OEM fit and detent locations for correct alignment

• Remove power from the appliance before attempting replacement
• Typically pulls off the control shaft; inspect for retaining clip or set screw
• If knob does not seat fully, verify shaft and index tab are undamaged

This shaft wheel pony is a genuine MTD part, sold individually. This shaft wheel pony can be used as a replacement part in a tiller. The purpose of a shaft wheel pony in a tiller is to function as a fully assembled shaft with hardened steel worms which connect the blades of the tiller to the motor of the tiller so that the blades can be rotated and cut through the soil.The shaft wheel pony in a tiller might have to be replaced if the shaft suffers irreparable damage in the form of puncturing, denting, cracking, scraping, eroding, or warping to the point of reduced or no functionality. If this occurs, the shaft wheel pony should be removed and replaced by this genuine OEM replacement part in order to guarantee safe use of the tiller for the operator. This replacement should be facilitated in accordance with the proper set of instructions sourced from a relevant appliance handbook or manual.This is a genuine OEM replacement part sourced directly from the manufacturer. It is sold individually. This shaft wheel pony is compatible with the following outdoor appliance brands: MTD, Craftsman, Cub Cadet, Troy-Bilt, Huskee, Yard Man, and Yard Machines.

This replacement part is a hex screw. This part is small but important in many types of equipment. Hex screws are used with washers or nuts to secure components within the equipment.If it has been stripped because of overtightening, it can come loose and fall out. Over time, a screw can corrode, as well, causing it to get stuck in place or break. If this is the case, it is recommended that this part be replaced.This is a genuine OEM replacement part manufactured by MTD. This part is sold individually.

This steam vent linkage is the mechanical connector that operates the appliance's steam vent, allowing controlled release of steam during cycles to prevent excess pressure and moisture buildup. Replaces a worn or broken actuator linkage to restore vent movement. What it does

• Transfers motion from the vent actuator to the steam vent so the vent can open and close properly.
• Helps release built-up steam during specified cycles to reduce excess moisture.
• Commonly replaced when the vent is stuck, does not move, or makes noise during operation.
• Supports normal vent sequencing—does not include electronic actuator or motor.

• One steam vent linkage

• Disconnect power (and gas if applicable) before beginning any repairs.
• Moderate disassembly of the cabinet or control area may be required; keep fasteners organized.
• Inspect surrounding components (springs, clips, actuator) for wear and replace if needed.