Bg21vw Parts

8-32 x .312 inch mounting screw for washers. Replaces lost, stripped, or damaged screws that secure panels, brackets, and components inside the unit.

Secures the power cord to your refrigerator's back panel. Replace this clip if it's broken, cracked, or missing to keep the cord organized and secure.

Secures panels, brackets, and components inside your refrigerator. Replace if the original screw is stripped, missing, or no longer holding parts firmly.

Secures wiring bundles inside your microwave. Replace this wire tie if it's cracked, broken, or missing to keep internal wires organized and secure.

Secures panels and components in place. Replace this fastener if stripped, corroded, or missing to restore proper alignment and eliminate rattling.

Refrigerator not cooling evenly or making rattling noises? A broken evaporator clip lets the coil shift, blocking airflow. Simple 10-minute fix.

Replacement oven door gasket that seals the oven cavity to maintain proper cooking temperature and improve energy efficiency. Replace if torn or worn.

Small button-style plug that covers unused holes or trim openings on your refrigerator. Replace when cracked, broken, or missing to restore a clean look.

Replacement mounting screw that secures internal panels, brackets, and components inside your refrigerator. Needed when original fastener is missing or damaged.

Washer won't spin or agitate? A worn drive coupling often causes grinding noises and lost motor power. This part connects motor to transmission.

Mounting screw for refrigerators. Secures panels, brackets, or internal components. Replace if stripped, missing, or damaged during appliance repair.

This main control harness routes power and signals between the appliance control board and components to restore reliable electrical connections and control functions. Replaces a damaged or burnt control wiring harness to help the appliance respond correctly to control inputs. What it does:

• Connects the main control board to switches, sensors, and power lines to enable normal control operation
• Commonly replaced for intermittent controls, burned connectors, or visible wiring damage
• Restores proper signal and power transmission when connector pins are loose or corroded
• Helps eliminate control-related failures tied to broken or shorted wiring

• One main control wire harness as shown

• Disconnect power before servicing to avoid shock or damage
• Match connector shapes and routing to original harness; secure with existing clips or ties
• Inspect mating connectors and terminals for damage; replace if necessary

This overload is a thermal protection device that mounts on the motor/compressor and opens the circuit when excessive heat or current is detected. Replacing a weak or failed overload helps restore safe startup and protects the windings from damage. What it does:

• Monitors motor/compressor temperature and current draw
• Interrupts power on overheat/overload to prevent damage
• Aids troubleshooting of start/run issues when paired with the start device
• Common symptoms: hums then clicks off, won't start, intermittent shutdown, frequent tripping

• 1 thermal overload protector

• Disconnect power before servicing; allow components to cool
• Access the terminal area on the motor/compressor; remove any cover
• Note/photograph wire positions; transfer wires and fully seat the new overload on the correct terminal
• Inspect the start relay, capacitor, and terminals for heat damage; replace any compromised parts