Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Perfectly! Replacing Agitator Shaft is not for the faint of heart. Replacing output shaft pinion gear on the bottom of the agitator shaft requires care, experience and patience with pressing/driving drift pins without damaging the gear itself. One slip of the drift/punch or press apparatus will ruin the gear/teeth face and will lead to failure of the transmission internally when put back into service. As best as I can tell the pinion gear is discontinued and no longer available so take care!... Read more
Size: 19 x 12 x 14 inch.
Size: 25-27 x 15-19 x 6-27 inch.
Installed a new switch after removing the front panel, it couldn't be any easier Read more
During reassembly after a thorough cleaning of the air conditioner, one of the vent side pins broke off. When I received the new vent, I tried changing my approach to the installation: I inserted the vent pin on the side that doesn't include a track, and then, instead of sliding the other pin through the track as I'd done in the past, I used a flat tip screwdriver to gently pry the side panel away from the vent and slid the new vent straight down into its slots (round pin for rotation, flat... Read more
Lower brake bearing
I first replaced the two drive belts and the motor springs. That didn't fix it although they did need replacing. I then replaced the two bearings and the brake assy. The washer runs like new. If you replace the brake assembly, you should also replace the bearings. It will save a tear down later on. The Maytag repairman wanted $600.00 dollars to do the job. I did it for less than $200.00. Read more
Found the wonderful parts diagrams you most generously share online and a couple of YouTube videos . I determined it should be repairable. In my cast the agitator shaft was frozen (rusted) in place. I was very fortunate to have been able to eventually remove it with the use of a lot of BP penetrating oil and heat. Long and short the replacement parts fit perfectly and the washer is running like new. Special thanks to the online support make my repair possible. Read more
Using your video then calling Tina, who researched a part I had that wasn't in video or parts list. She had me send in a picture and researched then called me back. The part was redesigned. She was very helpful. Read more