Dlex2550 Parts

This is the appliance's main electronic control board (PCB assembly). It manages power distribution and operating logic for key functions. Replacing a failed board can restore normal operation when the unit is dead, unresponsive, or behaving erratically. What it does

• Routes power and coordinates major loads (motors, heaters, fans, valves) based on sensor feedback and user settings
• Controls timing and modes for normal operation
• Monitors safety circuits and error conditions
• Common symptoms of a failed board: no power/won't start, blank or dead display, won't complete cycles, intermittent shutdown or clicking, erratic operation, recurring error codes

What's included

• One main control board (PCB) assembly

Install notes

• Disconnect power before servicing; allow capacitors to discharge fully
• Use ESD protection and handle the board by the edges only
• Photograph connectors; move any jumpers, covers, or brackets from the old board to the new one as required
• Inspect wiring and connected components for shorts, heat damage, or moisture before powering up the new board

This is an authentic OEM drum support roller sourced directly from the manufacturer for use in clothes dryers. During the drying cycle, the drum turns and tosses the clothes around to distribute heat. This drum support roller holds the drum in place as it rotates. Over time, the heat from the dryer can lead to the roller becoming worn. If the dryer is making squealing sounds or thumping when operating, the support roller is worn out and should be replaced. Before replacing the drum support roller, make sure the power is disconnected from the dryer. Remove the top and front panel of the dryer to reach the drum. The idler pulley and dryer belt are underneath the drum; remove these and then take the drum out of the unit and set it aside. Remove the mounting bracket holding the worn drum support roller. Remove and replace the worn roller. While the dryer is apart, inspect the remaining support rollers. Reverse the steps used and put the dryer back together. Power the dryer and make sure the drum turns.This is a black and white, rubber and metal part that is individually sold. It does not come with assembly hardware. This drum support roller is designed for dryers manufactured by LG, Kenmore, and General Electric.