Esf25lgre Parts

This adhesive-backed foam sealing strip provides a simple replacement to seal small gaps and cushion contact points on appliance doors and panels, helping reduce drafts, moisture intrusion, and rattling. What it does:

• Seals small gaps around doors, panels or assemblies to help limit air and moisture transfer and reduce condensation
• Cushions surfaces to minimize vibration and rattling noises
• Helps improve temperature retention by closing unintended openings
• Commonly replaced when foam is torn, compressed, detached, or causing drafts

• Verify the mounting surface is clean, dry and free of grease or old adhesive before applying
• Measure and trim the strip to fit; peel back adhesive liner and press firmly along the full length
• Avoid stretching the foam during installation for best seal and adhesion
• If adhesion is poor, remove residue and consider using a manufacturer-approved adhesive

This wire actuator engages the refrigerator dispenser paddle to activate water or ice dispensing. It restores reliable mechanical actuation for responsive dispenser operation without replacing the entire dispenser assembly. What it does:

• Translates paddle movement into the dispenser switch action so water or ice starts when the paddle is pressed
• Helps correct a dispenser that doesn't activate when the paddle is pushed
• Replaces a bent, broken or worn actuator wire that can cause inconsistent dispensing
• Works with the dispenser lever and switch assembly to restore proper alignment and motion

• Includes: 1 wire actuator for dispenser

• Disconnect power (unplug or shut off breaker) and turn off the water supply before starting
• Remove dispenser trim/paddle to access and replace the actuator; avoid forcing plastic clips
• Verify alignment with the dispenser switch and paddle during reassembly to prevent binding

This control board harness connects a refrigerator's control board to dispenser, sensor, and power circuits, restoring reliable signal and power routing for proper operation. Designed as a direct replacement for a single harness assembly. What it does:

• Routes power and signal lines between the main control board and fridge subsystems.
• Restores functionality when damaged wires or broken connectors cause intermittent or no response.
• Can resolve symptoms like unresponsive dispenser/controls, nonworking lights, or sporadic electronic behavior.
• Maintains correct wire routing and connector alignment to prevent shorts and communication errors.

• Disconnect power to the appliance before servicing to avoid shock or component damage.
• Handle connector ends gently and seat fully; do not bend pins.
• Route harness away from sharp edges, moving parts, and heat sources; secure with existing clips or ties.

This recessed dispenser trim restores the finished edge and appearance around a refrigerator's ice/water dispenser opening. It replaces damaged, dented, or missing trim to keep the dispenser area looking clean and protected. What it does:

• Covers and finishes the recessed dispenser opening for a seamless look
• Protects underlying cabinet edges from chips, dings, and wear
• Helps guide cups and containers into the dispenser area
• Common symptoms: cracked, bent, scratched, or missing trim; visible gap or rough edge around dispenser

• High-level replacement — typically snaps or screws into the dispenser recess; your model's service manual for fastener locations
• Disconnect power to the appliance before starting work to avoid accidental actuation of electrical components
• Use non-marring tools and light force to avoid scratching the clad finish
• If clips or fasteners are damaged, replace them to ensure a secure fit