Fef36ece Parts

A replacement wire shield for the stove/oven vent that protects wiring from heat and abrasion, helping maintain reliable oven vent performance and reduce wire damage risk. What it does:

• Shields vent-area wiring from heat and physical wear
• Helps prevent wiring chafe and shorting caused by rubbing or contact
• Supports safe routing of harnesses near the stove/oven vent
• Addresses symptoms such as exposed or frayed wires near the vent, burning smell, or intermittent electrical faults

• One wire shield as shown

• Disconnect power to the appliance before attempting any service
• Handle carefully to avoid bending or nicking the shield or adjacent wiring
• Reinstall using existing mounting points and fasteners; replace any damaged clips or hardware

Replace your range's oven vent tube if it's cracked, damaged, or missing. This duct channels hot air and steam from the oven cavity to the exhaust system.

Mounting plate for electric and gas ranges. Secures components in place. Replace if cracked, bent, or broken to restore proper structural support.

Lower wool shield for electric ranges. Installs beneath the cooktop to provide insulation. Replace if damaged, torn, or missing for proper heat protection.

Color: White. This is the left side backguard support. For right side use 316220214.

This left-side bisque end cap finishes and protects the refrigerator door edge, restoring a clean appearance and helping keep the door trim secure. It's a direct-fit replacement for worn, cracked, or broken end caps. What it does:

• Covers and protects the outer edge of the refrigerator door trim on the left side
• Restores a finished appearance when original trim is cracked, broken, or missing
• Helps keep door components and seals neatly aligned and supported
• Compatible with factory door trim to maintain proper fit and gap

• Read the appliance manual before beginning; unplug the appliance or turn off power to the unit when instructed by the manufacturer
• Remove any damaged trim carefully to avoid scratching the door finish
• Align the end cap with the door edge and snap or fasten per factory attachment points; use gentle pressure to avoid cracking
• If clips or screws are required, reuse original hardware or replace with OEM-specified fasteners

Replace a cracked or missing right-hand shield end cap on your range. This protective trim piece covers the end of the range shield for a complete finish.