Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
When I identified a leak coming from the Heating Coil, I saw that the Heating Element Nut on both sides were corroded and could not hold the heating element tight any more. I ordered replacement parts and the fix was very easy. As I was running the test afterwards, I discovered that there was a leak coming from under the door. I realized then that the reason the heating element nut corroded was because of a leak in the door. I ordered a new door gasket and door seal (that goes at the bottom... Read more
Took door off and replaced part My son did the work Read more
No.10 - 16 x 3/8
10 - 16 x 3/8 , hex
This replacement part is a bushing, and it is intended for use in different types of appliances. This is a genuine replacement part made by Frigidaire. This bushing is typically found in dishwashers but is compatible with other devices as well. The bushings are an important part of many appliances as they help reduce friction inside the machine during the different washing cycles. A new bushing might be needed if the current ones are broken or damaged. It is common that different machinery needs multiple types of bushings. These small but important parts are placed around tubes or poles and are meant to assist during the rotating or sliding mechanisms. Be sure the machine is completely powered off as the area with the bushings is often hot from friction. See the owner's manual for more exact instructions before attempting to replace this part. These bushings are sold separately and are OEM replacement parts. These bushings are compatible with appliances made by Frigidaire.
Does not include wheel and bushing assembly. For wheel and bushing assembly use part number 154522902.
Includes actuator
We took off the front door cover and found that the vent had failed some time ago- the flap was frozen open, the motor did not work. We removed the three screws and the vent came of- putting the new one back was just that simple except that I had to remove the protective paper from the adhesive covered gasket around the surface of vent. Testing showed that the flap was now free but did not close during the running cycle. I swapped the leads from the dispenser motor with those on the vent and... Read more
I put in 4 new parts ad gave it a try. had water under dish washer about the size of a half dollar , I dried it up and washed more dishes and pots. No leak that time, and it has been doing fine since. I'd say water was just what was laying on the water lines and shook off. If you see water the first time don't worry wipe it up and use it some more to see if it leaks. GOOD LUCK!!! Read more
Replaced a bad control board after the dishwasher quit heating. The buttons never worked completely but I was able to run the cycles I needed. Decided to fix it all at once and now the 5 year old dishwasher that gets used daily is like new. $200 vs $600+ for a new unit. Read more
Replaced control board and that fixed issue! Also replaced vent assembly due to occasional water leak . Old one showed signs where water leaked past the seal. New one had same design so hopefully will perform better Read more
Myself?? Console replacement went well. Should have anticipated the junk control pad....was a STICK ON getting it off was VERY TEDIOUS. But the repair gods were with me. Read more