Gdwti60r05ss Parts

This kick plate assembly replaces the lower access panel on compatible refrigerators and dishwashers to restore a finished look and protect internal components at the appliance base. It provides a clean, secure cover for the toe-kick area. What it does:

• Covers and protects the lower cabinet opening and components from dirt, debris, and accidental contact
• Restores the appliance's finished appearance at the base for a seamless look
• Helps direct airflow from vents located at the toe-kick area
• Replaces damaged, dented, or missing lower access trim to improve safety and aesthetics

• One kick plate assembly

• Remove power to the appliance before attempting removal or installation
• Typically fastens with clips or a few screws; retain hardware if reusing or replace if damaged
• Handle carefully to avoid scratching painted or plated surfaces during installation

Specs: 8-18 b por 1/2 ss

This is a genuine replacement screw used to secure components and panels on compatible GE appliances. It restores proper fit and prevents rattling or loose parts for safe, reliable operation. What it does:

• Secures panels, brackets, or internal components to maintain proper alignment
• Stops rattling or vibration caused by loose fasteners
• Replaces missing, stripped, or damaged screws to restore safe operation
• Helps maintain seals and clearances by holding parts firmly in place

• Screw

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Do not overtighten; snug until secure to prevent damage to components
• Keep removed fasteners organized to ensure correct reassembly

This dishwasher hose clamp secures internal hoses to pumps or fittings, helping prevent leaks and disconnections. Replace a weakened or damaged clamp to restore a tight, reliable seal at the connection.

• Provides clamping pressure to hold a hose on pump, sump, or drain fittings
• Helps stop water leaking at hose joints
• Resolves: loose or disconnected hoses, water under the unit/base, or poor draining from a slipped drain hose
• Replaces worn, rusted, or deformed clamps after service

• Disconnect power and turn off the water supply before servicing
• Pull the dishwasher forward as needed for access; place a towel or pan to catch residual water
• Seat the hose fully, then compress or tighten the clamp per its design; position just behind the hose barb bead
• Run a short cycle and inspect for leaks at the connection

This bearing hinge arm replaces a worn or damaged door hinge on compatible GE laundry appliances, restoring smooth opening and secure door alignment for safe, reliable use. It provides a stable pivot point and reduces binding and noise. What it does:

• Supports the appliance door and provides a smooth pivot with an integrated bearing
• Prevents door sag and helps maintain proper door seal and alignment
• Reduces squeaks, grinding, or sticking when opening and closing the door
• Restores secure door movement after hinge wear or damage

• One bearing hinge arm

• Disconnect power and water before starting any repair
• Remove the door or access panel to reach hinge mounting hardware
• Reuse existing fasteners only if undamaged; tighten hardware securely but avoid over-torquing
• Check door alignment and operation after installation; if binding persists, inspect other hinge or strike components

This pump motor hanger is the support bracket that secures the washer pump motor to the appliance frame, helping keep the motor stable during operation for reliable drainage performance. What it does:

• Holds the pump motor in the correct position to prevent vibration and misalignment
• Maintains pump-to-housing alignment so the drain pump can move water effectively
• Helps reduce unusual noise or movement caused by a loose motor mount
• Fits where the motor attaches to the washer chassis; replaces worn or bent hangers

• Disconnect power before starting any repair and follow basic electrical safety
• Basic hand tools required; keep original fasteners unless damaged
• Inspect pump and motor for wear while replacing the hanger