Ge326b1230p001 Parts

Can't connect your dryer to the app or smart home system? This Wi-Fi Bluetooth control board restores wireless connectivity for remote monitoring and control.

No hot water? This heating element warms water in your electric water heater tank. Includes gasket to seal connection and prevent leaks at tank wall.

Decorative nameplate that mounts on the appliance exterior to display the manufacturer's emblem. Replace if original badge is damaged, faded, or missing.

Water not heating or overheating? This upper thermostat control regulates temperature and prevents overheating. Moderate DIY repair restores hot water.

This electronic control assembly operates the oven's front control and display, restoring normal user inputs and timed cooking functions. It replaces a faulty control to help the oven accept settings, show the display, and run timed cycles reliably. What it does:

• Receives button/touchpad inputs and manages oven heating cycles and timers
• Controls oven temperature signals to the bake/ broil systems (allows programmed cook functions)
• Often used when the display is blank, buttons don't respond, or oven functions fail to start
• Works with the console to show time, temperature, and error codes

• One electronic control assembly

• Disconnect power at the breaker before replacing the control to avoid shock
• Handle the control by the housing; avoid static discharge and rough handling of the circuit board
• Keep mounting screws and wire connectors secure; verify connectors are fully seated before powering up
• Some ovens may require a short setup or clock reset after installation

This level regulator control manages the ice maker's water fill level to ensure proper ice production and reduce overflows. It replaces a faulty regulator to restore consistent water sensing and filling performance. What it does:

• Controls the ice maker water fill level so each cycle fills to the correct amount
• Helps prevent overfilling or underfilling that can cause poor ice quality or leaks
• Works with the ice maker assembly to time and stop water fill during harvest cycles
• Commonly replaces parts that cause continuous filling, no filling, or visible leaks

• 1 level regulator control

• Disconnect power to the appliance before starting any repair
• Handle wiring connectors and sensors carefully; match connector locations during reassembly
• Inspect surrounding components for damage before final testing
• Test for proper fill and cycle operation after reinstalling

This is a 10-32 x 1/2 screw with a hex washer-style head used to fasten appliance panels and components securely. It replaces missing or damaged fasteners to restore proper fit and reduce vibration. What it does:

• Secures panels, brackets, and trim to the appliance frame
• Provides a low-profile, washer-style bearing surface for even clamping
• Helps stop rattling and movement caused by loose or missing screws
• Designed for use where a 10-32 thread and 1/2" length are specified

• Disconnect power and water before servicing the appliance
• Use the correct 10-32 driver or socket to avoid stripping the head
• Tighten until snug; do not over-torque to prevent thread or part damage
• Replace with the exact screw size and type for safe, proper fit

Fix a water heater that won't heat properly or trips the breaker with this current sensor toroid. Common repair for GE electric water heaters.

This electronic control assembly manages oven functions and the user interface so bake/broil settings, timers and the display respond correctly. Replaces a failed control to restore normal oven operation and controls. What it does:

• Regulates oven heating cycles and user-selected cooking modes
• Powers and manages the control display, clock and touch/knob inputs
• Can cause symptoms such as an unresponsive control panel, incorrect temperature, or oven not starting
• Works with the oven's wiring harness and surface components to execute user commands

• Disconnect electrical power to the oven before beginning service
• Handle the control and any attached display glass carefully to avoid damage
• Reinstall all mounting hardware and confirm correct function after restoring power