Ghs22jfta Parts

Plastic cover that protects the evaporator coil in your refrigerator. Replace if cracked, broken, or missing to restore proper airflow and protection.

Mounting plate for refrigerators. Secures internal components in place. Replace if cracked, bent, or broken to restore proper support and stability.

Protects and diffuses your refrigerator's interior light for even illumination. Replace if cracked, yellowed, or missing to restore proper lighting and safety.

Replacement sliding basket for your refrigerator. Installs inside the fresh food compartment. Order a new basket if yours is cracked, broken, or missing.

Molded water reservoir that stores and directs water to your refrigerator's dispenser and ice system. Replace when cracked, damaged, or leaking.

Plastic trim piece that fits along the edge of refrigerator shelves. Replace if cracked, broken, or missing to restore shelf appearance and edge.

Replacement drip pan for your refrigerator. Installs beneath the unit to collect condensation. Order a new pan if yours is cracked, damaged, or missing.

Secures water, drain, and refrigerant tubing to prevent movement and wear. Replace if tubes are loose, vibrating, or damaged. Verify fit with model number.

Ice maker not dispensing cubes or producing hollow ice? This ice maker ejector controls the ice release cycle. Moderate DIY repair for most models.

Ice clumping together in your ice maker? The heat conductor prevents ice from freezing properly. Direct replacement part for refrigerator ice makers.

Refrigerator running constantly or freezing food? This defrost thermostat regulates temperature cycles to restore consistent cooling and prevent frost buildup.

Replace a worn, broken, or missing door spring in your refrigerator. This spring provides tension for smooth door operation and proper closure.

Defrost drain trough for side-by-side refrigerators. Channels water from the freezer evaporator to the drain tube. Replace if cracked or broken.

This water inlet tube supplies water from the refrigerator's supply to the dispenser and ice maker, restoring proper flow and preventing routing issues. It's a direct-fit replacement that helps stop leaks and restore water delivery. What it does:

• Directs water from the house supply to the refrigerator's internal water system.
• Restores water flow to the dispenser and ice maker when a damaged tube is blocking supply.
• Prevents leaks and water pooling caused by cracked, pinched, or corroded inlet tubing.
• Works with other inlet fittings and valves to maintain proper water routing.

• Shut off the refrigerator power and water supply before starting any work.
• Remove access panels as needed and relieve any residual water pressure in the line.
• Use proper tubing connectors and tighten fittings to manufacturer torque—inspect for leaks after restoring water.
• If you find additional damaged fittings or clamps, replace them to ensure a leak-free install.

This label module cover is a replacement outer cover that protects the control module label and front-top trim area while restoring a clean, finished appearance. It fits over the module opening and matches white appliance trim. What it does:

• Protects the control module label and underlying components from dirt and accidental contact
• Restores a clean, undamaged appearance when the original cover is cracked, faded, or missing
• Keeps important model/serial/label information visible and secure
• Helps prevent loose wires or small debris from contacting the module area

• One label module cover (white), as shown

• Disconnect power to the appliance before starting any work
• Typically installs by snapping into the control-module opening or fastening with screws—retain any original fasteners
• Handle carefully to avoid cracking the new plastic during alignment