Gtd45gasj3ws45easj2w2 Parts

This orange jumper harness routes signals and power between wiring harness sections to restore proper electrical continuity. It's a direct-fit replacement that helps clear connection faults and re-establish reliable component communication. What it does:

• Provides a clean, color-coded connection between harness points to maintain circuit continuity
• Replaces damaged or brittle wiring that can cause intermittent operation or loss of function
• Prevents open circuits and improves connector seating for reliable appliance performance
• Used where a short harness run or jumper is required to bridge terminals

• Unplug the appliance or disconnect power before beginning work
• Match wire colors and connector shapes to the original; ensure connectors are fully seated
• Inspect surrounding wiring and connectors for heat or damage and replace if needed

This idler support bracket holds the dryer idler pulley in the correct position so the drive belt stays routed and tensioned, helping the drum turn smoothly. It replaces a worn or broken bracket to restore proper belt alignment and reduce belt slippage. What it does:

• Secures the idler pulley to the dryer chassis so the drive belt maintains correct tension
• Keeps the belt aligned to prevent rubbing, squealing, or premature wear
• Helps the drum turn freely by maintaining consistent belt routing and tension
• Commonly replaced when the bracket is cracked, bent, or the idler pulley mounting fails

• One idler support bracket

• Disconnect power before starting any repair
• Access typically requires removing the dryer's front or lower access panel; follow model-specific disassembly steps
• Inspect the idler pulley and drive belt; replace any worn components together to ensure reliable operation
• Use basic hand tools; avoid forcing fasteners and follow torque/fastening recommendations in the service manual

This replacement gas valve bracket secures the oven/range gas valve to the chassis, keeping the valve aligned and stable for reliable gas flow. Fits where the valve mounts to the appliance frame to restore proper positioning and reduce vibration. What it does:

• Holds the gas valve firmly in place to prevent movement or misalignment
• Maintains correct spacing between the valve and burner assembly for safe operation
• Helps eliminate rattling or vibration caused by a loose or damaged bracket
• Supports consistent valve operation that can reduce ignition or heating issues related to a loose mount

• One gas valve mounting bracket

• Shut off gas supply and unplug the appliance before starting any work
• Only install on the mount specified by the OEM; use correct fasteners and torque to avoid stripping or deformation
• After installation, check all gas fittings and connections for leaks using a gas leak detector or soapy-water test

This genuine replacement wire harness routes power and signals between a range of appliance's control and electrical components to restore reliable connections and proper operation. What it does:

• Transfers power and control signals between controls, switches, and motors or sensors
• Replaces damaged or frayed wiring that causes intermittent operation or component failure
• Helps resolve symptoms such as no power to a circuit, intermittent function, or unresponsive controls
• Maintains factory routing and connector fit for a secure, vibration-resistant connection

• Disconnect power (unplug or shut off breaker) before starting any repair
• Handle connectors gently; match connector shapes and pin counts before installing
• Route and secure the harness using existing clips or ties to avoid heat or moving-part contact