Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
Follow the trio ubshooting flow chart inside of the microwave panel - and read articles on this website. Turned out to be a thermostat that had popped and gone bad. Replace the thermostat and it is good to go. Read more
The hubby removed vent and the bar that it all attaches to and replaced new bar ,new springs and assemble back together . The vent cover attaches to this assembly and screwed it back. It works like a charm. Read more
Went shopping for new microwave with wife. Lucked out. Couldn't find one she liked. Went home, took door apart, ordered part. At the door the next day, put back together in 5 minutes. Walla, saved hundreds of bucks. Thank you Appliancepartspros. Read more
I have one of those combo units with the microwave on top and the oven on the bottom. The thermometer switch located on the upper right side mounted on top of the magnetron read open on a continuity test. Replaced the thermal fuse. Everything works fine now. Note: The thermal switch on the left side read closed, the fan switch on the lower right side read open. I just watched some youtube videos on what and how to test the components. The 20A fuse was good. So I tested the thermal... Read more
I had to remove the microwave from the range and then remove the cover from the microwave to determine the exact problem. After a visual inspection then discharging the high voltage capacitor, I used a meter to test the high voltage diode and fuses. After using the meter to ohm out the magnetron, I removed it from the unit, and seeing that the hole in the end of the magnetron's tube was enlarged and burnt, as if it was arcing, I assumed it was the bad part. I ordered the parts from Appliance... Read more
First I had saved the metal pivot brackets and springs from the old piece, I remounted them on the new frame and carefully installed the 2 tension springs. After that was done I carefully installed the new completed vent cover by first positioning it to the left, in place then carefully sliding it to the right. All that holds it in place is 2 screws on the top of the micro. Read more
I ordered a new ring. The part came quickly and fit perfectly. Where before the glass tray would rumble because that wheel would constantly fall off, the unit is back to operating as new. Read more
Dropped unit about six inches by support bolts (cabinet access) and replaced socket light assembly, replaced stovetop bulbs, replaced motorized vent grill. Replaced interior light bulb. I think it defies common sense but you have to drop the unit from its moorings to replace the interior bulb. Owner's manual says it is a two-man job, which compounds this engineering debacle. Actually you can lower it rather than completely deinstall. I had also not been able to replace the stovetop bulbs,... Read more
After tracking the source of a prominent noise to the vent motor I removed it and found a replacement part to install. It went very well, and the new motor works noiselessly. Read more
Replaced Motor Turntable. Read more
Removed noise filter and replaced with new one purchased at Appliance Parts Pros Read more