Kenmore 417 4405 2400 Parts

This Halogen Bulb is an OEM part for Bosch Ranges. It provides illumination for the range's interior. Continuous use or high temperatures can cause the bulb to burn out or fail.

What Causes a Bad Halogen Bulb: 
Repeated heating and cooling cycles, along with continuous use, can cause the halogen bulb to burn out or break.

Symptoms of a Bad Halogen Bulb:

• The bulb is not lighting up
• Visible signs of damage or a broken filament
• Flickering or intermittent lighting

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This is a carriage bolt, which is found on lawnmowers, snowblowers, and many other types of lawn and garden equipment. The carriage bolt is made of metal and the location will vary based on the model of the tool. The carriage bolt is used to fasten together two components on lawn and garden equipment. It can become damaged, break, or stripped and will need to be replaced.If the carriage bolt is broken, stripped, or has damage, a wrench will be needed to replace it. Make sure that the spark plug wire has been disconnected and the tool is turned off before you begin. Use the wrench to remove the carriage bolt before installing the new part in the same location. Replace any additional disassembled components removed to gain access to the bolt before using the tool.This carriage bolt is sold as an individual component. It is a genuine OEM replacement part that is sourced directly from the manufacturer. The bolt is designed to work with lawnmowers, chainsaws, snowblowers, tillers, and leaf blowers manufactured by Yard-Man, Bolens, Montgomery Wards, Huskee, MTD, Yard Machines, Husky, Troy-Bilt, Ryobi, Cub Cadet, and Craftsman.

This spin speed knob lets you select wash spin settings so you can adjust water extraction for different loads. It replaces a worn, cracked, or loose dial to restore clear speed selection and smooth control. What it does:

• Selects the washer's spin speed setting for proper water extraction
• Restores firm, accurate dial operation when original knob is loose or broken
• Helps prevent accidental speed changes during a cycle
• Matches OEM fit and detent locations for correct alignment

• Remove power from the appliance before attempting replacement
• Typically pulls off the control shaft; inspect for retaining clip or set screw
• If knob does not seat fully, verify shaft and index tab are undamaged

This steam vent linkage is the mechanical connector that operates the appliance's steam vent, allowing controlled release of steam during cycles to prevent excess pressure and moisture buildup. Replaces a worn or broken actuator linkage to restore vent movement. What it does

• Transfers motion from the vent actuator to the steam vent so the vent can open and close properly.
• Helps release built-up steam during specified cycles to reduce excess moisture.
• Commonly replaced when the vent is stuck, does not move, or makes noise during operation.
• Supports normal vent sequencing—does not include electronic actuator or motor.

• One steam vent linkage

• Disconnect power (and gas if applicable) before beginning any repairs.
• Moderate disassembly of the cabinet or control area may be required; keep fasteners organized.
• Inspect surrounding components (springs, clips, actuator) for wear and replace if needed.