Lde3037 Parts

A circular lug designed to join a stripped wire to a threaded terminal for a secure electrical connection. Helps restore reliable contact at terminals and reduces the chance of intermittent power or arcing at connection points. What it does:

• Provides a strong mechanical and electrical connection between a wire and a screw or bolt terminal.
• Helps prevent loose connections that can cause intermittent operation, sparking, or overheating.
• Commonly used where a ring-style termination is required for safe, stable wiring.
• Works with properly sized wire and fasteners to maintain consistent conductivity.

• Always disconnect power to the appliance before inspecting or replacing electrical parts.
• Use the correct lug size and gauge for the wire and terminal; crimp or solder per manufacturer recommendations.
• Tighten terminal hardware to the appliance manufacturer's specified torque; avoid over-tightening which can damage the lug or terminal.
• If wiring insulation or the terminal is damaged or corroded, replace the affected components rather than reusing them.

This single wire harness connects electrical circuits inside the appliance to restore reliable power and signal routing. It replaces a damaged or worn harness to help components receive proper power and reduce intermittent failures. What it does:

• Reestablishes electrical connection between internal components and control circuits
• Restores power/signal routing when factory wiring is damaged, frayed, or burnt
• Helps stop intermittent operation, no-power conditions, or component failures caused by wiring faults
• Matches OEM wiring colors and connector types for a direct replacement

• Disconnect power before servicing to avoid shock or injury.
• Compare harness shape, connector count, and pin orientation to the original before installation.
• Route harness away from sharp edges and heat sources; secure with existing clips or ties.
• If connectors are damaged or pins bent, replace the harness—do not attempt temporary fixes.

This hinge bracket secures the appliance door hinge to the cabinet, restoring proper door alignment and reliable opening/closing. Designed to replace a worn or damaged hinge support and help prevent further door sag or misalignment. What it does:

• Provides a stable mounting point for the door hinge to keep the door aligned and sealed.
• Restores smooth door opening and closing when the original bracket is bent or broken.
• Reduces hinge play that can cause rubbing, uneven gaps, or difficulty latching.
• Helps prevent air leaks that can affect cooling performance when door alignment is compromised.

• One hinge bracket.

• Disconnect power (unplug or shut off circuit) before beginning repairs to avoid injury.
• Support the door while removing hinge fasteners to prevent it from falling; use a second person if needed.
• Retain and reuse any original screws or mounting hardware unless replacement hardware is explicitly included.
• After installing, check door alignment and seal; adjust hinge tension or position as required.

This sheath heater is the protective sleeve that surrounds a dryer's heating element, helping keep the element secured and directing heat where needed for efficient drying. Replaces a worn or damaged sheath to restore proper heater alignment and airflow. What it does:

• Protects and supports the heating element assembly to prevent contact with other components.
• Helps direct heat and airflow through the dryer drum for consistent drying performance.
• Commonly replaced when a cracked or melted sheath is found during heater repairs.
• Installed alongside a heating element or thermal fuse when troubleshooting no-heat conditions.

• Disconnect power before servicing; electric dryers present shock and burn hazards.
• Access may require removing the dryer drum and control panels—follow the factory service manual.
• Inspect the heating element and wiring while replacing the sheath; replace damaged components as needed.