Lfid2459vf1a Parts

This pump harness connects the washing machine's drain pump to the main wiring, restoring power and signal to the pump so it can remove water during the drain cycle. Replaces a damaged or corroded wiring harness for reliable draining. What it does:

• Delivers electrical power and control signals to the drain pump so the washer can pump out water
• Replaces frayed, burned, or corroded connector wires that cause intermittent or no-drain conditions
• Commonly used when the pump does not run, the washer won't drain, or the pump hums without spinning
• Restores factory-style connections and terminal fit for a secure electrical hookup

• One pump harness with factory-style connectors

• Disconnect power before inspecting or replacing the harness to avoid shock or injury
• Verify connector orientation and fully seat terminals to prevent loose connections and arcing
• Inspect pump and nearby wiring for damage; replace any burned or brittle components

A replacement mounting bracket that secures appliance components in place to restore proper alignment and reduce movement. Use this bracket when panels or internal parts feel loose or shift during operation. What it does

• Provides a secure mounting point for panels, assemblies, or internal components.
• Helps prevent vibration, rattling, or noise caused by loose parts.
• Maintains alignment so doors, panels, or mechanisms operate smoothly.
• Supports safe, stable installation of connected parts.

• Disconnect power before beginning any repair.
• Retain original screws/fasteners; reinstall in the same orientation.
• Basic hand tools are typically required; avoid over-tightening to prevent damage.

This housing assembly is the main structural enclosure that supports and protects internal appliance components while helping direct airflow and reduce vibration. Replacing a damaged housing restores proper component alignment and safe operation. What it does:

• Encloses and secures internal parts to maintain correct alignment and support
• Channels airflow for efficient operation and helps prevent overheating
• Reduces vibration and noise caused by loose or cracked housings
• Prevents debris and moisture from reaching sensitive components

• One housing assembly

• Disconnect power (and gas, if applicable) before starting any repair
• Remove exterior panels as needed to access the housing; keep fasteners organized
• Handle edges carefully—metal parts can be sharp
• Ensure all connected brackets, seals, and mounting hardware are reinstalled and secure before testing

This clamp secures a hose or small tubing to keep it in place and reduce movement or vibration. It helps prevent rubbing, kinking, and minor leaks by holding connections tight where a molded clip or screw clamp is required. What it does:

• Holds water or drain hoses, vent tubing, or small lines firmly in place
• Prevents rubbing and vibration that can cause premature wear or noise
• Helps maintain a sealed connection that reduces the chance of minor leaks
• Stops hoses from shifting out of position during normal operation

• Disconnect power and turn off water supply before accessing the component area
• Remove any access panels needed to reach the hose or tubing; use appropriate pliers or a screwdriver if applicable
• Position clamp over the tubing and secure so the hose is held without pinching; verify there is no kinking
• After installation, restore power/water and run a short test to check for proper fit and leaks