Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Fix excessive vibration or a loose spin basket with this washer tub bolt. Secures the inner tub to the drive hub assembly for stable operation.
Replacement mounting screw for compactor panels, brackets, and internal components. Replaces stripped, rusty, or missing hardware for secure assembly.
I fixed it myself. Read more
Plastic retainer clip that secures the top cabinet panel to the washer chassis. Replace if cracked, broken, or missing to restore alignment and prevent rattling.
I replaced the fill valve assembly with a new one. Had to look carefully at the parts diagrams to make sure I ordered the right one since the serial number break old vs. new didn't seem to match the number on my machine. On this particular machine you don't need to pull it out too far from the wall-leave the hoses connected to the valve, remove the screw holding the valve bracket, and pull into the washing machine where you can easily access the hose ends. A putty knife is needed to open... Read more
10-24 x 0.50 inch hex head nickel screw for dryer assembly. Replace missing, stripped, or corroded screws that secure panels and components.
Replacement screw secures panels, brackets, and trim on washers and dryers. Replace missing, stripped, or damaged fasteners to restore proper fit.
Loose or vibrating parts? This threaded retaining locknut secures rotating components like shafts and pulleys. Simple DIY fix takes minutes with basic tools.
Stabilizer bracket secures internal components in your washer to reduce movement and vibration. Replace if cracked, broken, or missing to restore alignment.
I followed the Appliance Parts Pro's advice videos for the Maytag MAV6451AWW Atlantis washer on replacing the snubber ring and the suspension springs. Everything went just fine except replacing the two rear most suspension springs. None of the videos illustrated REINSTALLING the REAR springs which is extremely difficult because you can't get enough leverage with your arm extended. Observing my frustration, my wife recommended taking off the back side. You can't simply take off the back,... Read more
Guides and tensions the drive belt in your dryer. Replace this pulley if it's worn, cracked, or no longer spinning freely to restore smooth drum rotation.
Secures wire harness connections in your washer. Replace if clip is broken, cracked, or missing to prevent loose wiring. Verify fit with your model number.
Plastic snap-in clip secures washer panels and trim pieces, preventing rattles and sagging. Replace when broken or loose to restore secure fit.
Fix a washer that won't fill, fills slowly, or leaks during the fill cycle. This water inlet valve controls water flow into your washer. DIY repair.
Secures washer hoses to fittings for leak-free connections. Replace when worn, cracked, or lost to keep hoses stable. Verify fit with your model number.
Fix igniter sparking issues or non-responsive controls with this range rocker switch. Direct replacement part for common control panel failures.
Fixes squealing or slow stopping at end of spin cycle. This spring maintains brake tension so the basket stops promptly. DIY repair takes about 1 hour.
I replaced the: brake stator, rotor, and snubber ring. I did need to remove the stator which allowed the spring to decompress. I used 2 C-clamps to control the force when it was removed. To re-secure all the components I stood on the stator to compress the 200lbs spring until the screws could take the load safely. The entire thing took about an hour to slowly go through everything. Read more
Usually ships within 4 - 14 days
Gray selector knob for washer control panels. Replaces broken, cracked, or missing knobs. Push-on installation. 1-inch base, 2-inch handle diameter.
Replaced it Read more