Maytag Dwuu4910aax Parts

This upper spray arm circulates and directs pressurized wash water to the dishwasher's top rack for even cleaning and rinsing. Replacing a damaged or clogged arm restores proper water coverage and helps improve top-rack wash results. What it does:

• Spins and sprays water across the upper rack to reach dishes, cups and glassware
• Replaces cracked, broken or blocked arms that cause poor cleaning on the top rack
• Prevents uneven water distribution that can leave spots or food residue on upper-rack items
• Works with the dishwasher's wash pump and plumbing to maintain normal spray patterns

• Turn off power to the dishwasher at the circuit breaker before servicing
• Remove the upper rack and clear any debris or obstructions before installing the new arm
• Install by seating or fastening per the original hardware; ensure the arm spins freely and is not rubbing

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

This retainer lever secures and positions a moving component inside the appliance so doors, trays, or assemblies operate correctly. Replacing a worn or broken lever restores proper engagement and prevents loose or misaligned parts. What it does:

• Holds and guides a mating part or linkage in place to ensure consistent engagement
• Prevents assemblies from slipping or coming out of position during use
• Helps restore normal opening/closing or indexing behavior when the original lever is cracked or broken
• Works as a direct-fit replacement where the factory lever has failed

• One retainer lever

• Install with power disconnected and any moving assemblies supported or restrained
• Inspect adjacent clips, pins, or fasteners and replace if damaged—only the listed lever ships
• Use basic hand tools; avoid forcing components—ensure correct alignment before fastening

This single OEM screw secures trim and small panels on compatible appliances, restoring proper fit and preventing rattles. Use it to replace a missing or stripped fastener for a secure, flush finish. What it does:

• Fastens trim, control panels, or small appliance components to the cabinet or support brackets
• Restores proper alignment and reduces vibration or rattling caused by a missing screw
• Replaces stripped, lost, or corroded fasteners to improve overall fit and finish

• One screw (quantity: 1)

• Use the correct driver and size to avoid stripping the head or threads
• Hand-start the screw to ensure proper thread engagement before final tightening
• Do not overtighten; stop when snug to avoid cracking plastic trim or damaging threads
• Disconnect power or follow manufacturer safety guidelines before servicing electrical appliances

This genuine replacement screw secures panels and components on compatible Frigidaire appliances, helping restore proper fit and reduce vibration or loose parts for safe, quiet operation. What it does:

• Fastens panels, brackets, and small components to appliance chassis
• Restores secure attachment to eliminate rattling or gaps
• Helps maintain alignment of covers and control panels
• Prevents further wear caused by loose or missing hardware

• Use the correct screwdriver or driver bit to avoid stripping the head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Disconnect power before working near electrical components or wiring
• Replace all like-for-like for even fit