Maytag Mdb6000aww Dishwasher Parts

I knew from experience it was a clogged secondary filter. We keep a kosher kitchen and it's big enough to have 2 dishwashers......one for meat dishes and one for dairy dishes. The meat one tends to get clogged more than the other one, as it is dealing with animal fats that tend to leave residue inside the secondary filter. The filter is almost impossible to clean, so buying a new one is the easiest solution. I have done this before. Change the filter, clean up any other filters that are... Read more

Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more

Replaced the water injector and seal. Read more

I pulled the dishwasher out and replaced the spray arm. Not hard at all. Took about one hour. Read more

Ordered the new o-rings for the pump housing and main filter screen unit. Cleaned all water hardness and other debris out of all parts. Main filter and inside parts clogged with water hardness/limescale and other debris. The 3" wide round filter internal was completely clogged with debris and some of the filter holes we crystallized with water limescale. The pump was in good shape but all the filters and parts just needed to be cleaned. Some useful tips on this Magtag Jet Clean... Read more

My son fixed it. Problem was one of the spinner pieces had worked itself loose and jammed the large arm from freely spinning. Read more

Still not completed, have to order part #PS11747606. When I receive it, I only have to assemble parts Read more

• Not drying dishes properly

Removed 8 screws that retain inner door to outer door. Removed rinse aid dispenser nut and replaced O-ring around dispenser. Also, removed 2 screws that retain the latch assembly and replaced rubber grommet around latch lever that retains soap dispenser door. Read more

Lower spray bar had what looked like spaghettis blocking & protruding from holes on top. Upon further inspection found to be some type of fiber. Further, inspection revealed fiber came from rinse arm. Ordered a new spray bar from you, arrived in three days. Clean all including filters/spray bar put all back together ran like new. The time listed below includes troubleshooting and a little head-scratching. Read more

The foam was shot on the detergent cup lid. Hard as a rock. Causing caking problems, dribble down the inside wall of the door and leaving lumps of detergent. Cut the door in half wit aviation snips and pulled out the two halves. Discovered at this point that the spring had gone soft. Bought one ahead of time, so I was set. Put the spring on the left pin, put the spring pin in the door, slipped the door into place (open) and put the right pin in with pliers. Door snaps open now. Read more