Maytag Mzd2667heq Parts

This air block is a small plastic baffle that helps direct and control airflow inside the appliance, maintaining even temperatures between compartments and improving overall cooling performance. What it does:

• Channels or blocks internal air flow to balance temperatures between compartments
• Helps prevent warm or cold spots caused by unrestricted airflow
• Reduces the chance of frost buildup from misdirected airflow
• Works with the appliance's venting system to maintain consistent cooling

• Disconnect power to the appliance before starting any service
• Handle the plastic part gently to avoid cracking; align tabs/slots before snapping into place
• No special calibration is usually required; verify airflow and temperature after reassembly

This freezer basket trim restores the finished edge and supports the freezer basket so contents stay secure and slide properly. It replaces cracked or broken trim to improve fit and reduce rubbing or uneven basket seating. What it does:

• Replaces damaged or missing trim on the freezer storage basket
• Helps keep the basket seated and reduces lateral movement or snagging
• Restores the finished appearance of the basket opening
• Can stop noise caused by a loose or misaligned basket

• Remove the freezer basket before installation for easier access and to avoid damage
• Trim typically snaps into place; align tabs and press firmly until seated
• Use a non-marring tool if needed to pry off old trim; avoid excessive force
• Disconnect power or follow appliance safety guidelines before working inside the freezer

This replacement temperature control housing secures and protects the appliance's thermostat/temperature control assembly and helps position it for accurate sensing. Replaces a cracked or damaged housing to restore proper mounting and protection. What it does:

• Holds the temperature control/thermostat securely in the correct position
• Protects the control assembly from vibration, moisture, and debris
• Ensures the temperature sensor/probe is properly located for accurate readings
• Resolves symptoms like a loose control, intermittent temperature sensing, or visible housing damage

• One temperature control housing

• Only install with power disconnected to avoid shock or damage
• Retain all original fasteners or replace with OEM-equivalent hardware
• Test or replace the control module (housing does not include the control)

This side ladder is a dishwasher rack support that stabilizes the rack and secures the tine assemblies so dishes load and slide properly. It restores proper rack alignment and helps prevent sagging or mis-tracking. What it does:

• Supports the side of the dishwasher rack and keeps the rack level during cycles
• Secures and guides tine assemblies so dishes stay upright
• Helps the rack roll smoothly on the track and prevents catching or misalignment
• Commonly replaced when the rack leans, tines are loose, or the rack does not track correctly

• One side ladder as shown

• Disconnect power to the dishwasher before starting work and, if applicable, turn off the water supply
• Remove the rack to access and inspect ladder clips or fasteners before removing the old ladder
• Reinstall fasteners securely and ensure the rack tracks and rolls smoothly before restoring power
• Use care around sharp edges and wear gloves if needed

This door hinge restores smooth, controlled door movement and a tight, secure close. Replace a bent or worn hinge to correct doors that sag, bind, or won't stay closed, helping your appliance seal properly and perform as designed.

• Supports and guides the door through its full range of motion
• Helps keep the door aligned so the gasket compresses evenly for a proper seal
• Controls closing action and stop position to protect the door and frame
• Common symptoms: door won't close flush, sags, pops open, or moves roughly/squeaks

What's included: 1 door hinge assembly Installation notes:

• Disconnect power at the breaker and allow the appliance to cool completely before servicing
• Support the door; follow the service manual for door removal. Engage hinge locks or use retaining pins if equipped
• Transfer any screws/brackets from the old hinge to the new and install on the correct side if the design is side-specific
• Ensure the latch engages and the gasket seals uniformly all around