Sm-19187St Parts

A small molded clip that secures appliance wiring and harnesses to the cabinet, helping keep wires in place and reducing wear or rubbing. Use this clip when a loose or shifted harness needs a reliable anchor point. What it does:

• Fastens wiring or harnesses to the cabinet to prevent movement and chafing
• Keeps wires routed away from heat, moving parts, and sharp edges
• Helps reduce vibration noise caused by loose wiring
• Can prevent intermittent electrical issues caused by damaged insulation or connectors

• Disconnect power before accessing internal wiring or panels
• Remove the panel or trim needed to reach the original clip location
• Press the clip into the factory mounting hole or snap the wire into the clip until secure
• Inspect nearby wiring and harnesses for damage; replace any damaged wiring before reassembly

Washer for oven fan motor mounting assembly. Replaces cracked, worn, or missing washers that secure the motor. Essential hardware for proper installation.

Replacement timer mounting screw for dryers. Secures the timer to the control panel. Required when original screw is stripped, missing, or damaged.

This cable tie secures wiring and small hoses inside the appliance to prevent rubbing, snagging, and vibration-related movement. It's a simple replacement part for restoring proper wire routing and keeping components tidy and safe. What it does:

• Holds wiring harnesses and loose cables in place to reduce wear and chafing
• Helps prevent wiring from contacting hot or moving parts
• Reduces noise caused by loose wires or hoses
• Keeps connectors and lines routed for reliable operation

• Disconnect power to the appliance before servicing
• Route wiring as shown in the appliance wiring diagram or photos, then cinch the tie snugly—do not overtighten
• Trim excess tail and ensure the tie does not stress the wire insulation
• Replace any damaged wiring or insulation discovered during installation

This replacement clamp secures flexible hoses and small tubing on refrigerators and freezers to prevent leaks and keep connections tight. It restores proper hose routing and helps stop drips where a loose connection causes water or coolant escape. What it does:

• Secures rubber or plastic supply and drain hoses to fittings and barb connections
• Prevents leaks caused by loose or slipping hoses
• Keeps lines routed and restrained to reduce vibration and wear
• Helps maintain a sealed connection at water inlet, drain, or appliance plumbing

• One hose clamp

• Inspect hose and fitting for damage; replace any cracked or brittle hoses before installing clamp
• Position clamp over the barbed fitting and tighten evenly until snug; avoid over-tightening which can damage the hose
• Disconnect power and shut off water supply before servicing water lines

Drive coupling for washer dryer combo units. Connects the motor to the transmission. Replace if cracked, worn, or broken to restore proper operation.