Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replace your washer's cracked or broken lid hinge. This right-hand side hinge secures the washer lid and allows smooth opening and closing operation.
With the parts supplied from your company. The lady that took my order was good at her job. All the parts were correct and fit. I thank you for the service that recieved. Read more
Touch-up paint for appliances in almond color. Repairs chips, scratches, and worn spots on ovens, refrigerators, microwaves, and dryers.
Replaced. Shippping was very fast. A good experience. Read more
Gasket sealer adhesive for dryers and laundry appliances. Bonds and seals gaskets during installation or repair. Replace when worn or missing.
Suspension skate plate mounts under the washer drum to support the tub assembly. Replace if cracked, broken, or warped. Includes suspension pads.
Washer lid hinge attaches the lid to the cabinet, allowing smooth opening and closing. Replace if cracked, rusted, broken, or causing lid misalignment.
Fix dryer electrical connection issues with this terminal. Common when dryer won't start or power cuts out. Simple plug-in repair for most models.
Washer won't spin or makes noise during spin? This clutch spring cap maintains proper tension in the drive assembly. Quick 5-minute DIY repair.
I bought a clutch liner kit installed it in 5 minutes now it spins faster than ever. Read more
Knurled pin secures knobs or dials to control shafts in washers. Replace if the original is missing, worn, or damaged to stop loose or spinning knobs.
Weekend laundry became very noisy, our 1987 Whirlpool washer began doing a dance across the floor and the drum was banging into the inner cabinet. After doing some research and watching a few videos on Appliance parts pros website. I inspected the washer and noticed one leg the rubber coating disintegrated, decided to change all four legs, springs and lid switch. Hardest part of the job is getting the cabinet together. Ops check good. Read more
Secures the control panel to the washer cabinet. Replace if your console strap is cracked, broken, or missing, causing the control panel to sag or shift.
Fix dryer electrical connection issues with this terminal. Used for wiring connections in heating and control circuits. Simple installation in minutes.
Gray acrylic spray paint for coating worn or chipped dryer drum interiors. Restores the protective finish when the original coating is scratched or flaking.
Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do Read more
Ground screw secures transmission housing and console components in washers. Replaces missing, stripped, or corroded screws. 10-24 x 3/8 inch fastener.
Replaced timer control unit, first time doing this. Read more
Leaking washer during drain cycle? This drain hose clamp secures the connection to prevent water leaks and hose pull-off from vibration or pressure.
Replacement washer lid hinge that supports and aligns the washer lid for smooth opening and closing. Needed when original hinge is broken, cracked, or worn.
I removed the old broken hinge and replaced it with the proper new part. Two screws out, place hinge and screw it in place. Easy and quick. Read more
Washer won't fill to correct level or overfills? This pressure switch detects water levels to control fill cycles. Simple 5-10 minute DIY repair.
At first I thought the water level fill switch might be bad because I was not sure if the hose was plugged in when I opened the panel. Then while waiting for the parts and taking a little more time looking at the schematics in order for the water level fill switch to flood over it would also take the overflow switch to fail as well. I could not recall if the water kept flowing after I unplugged it or not. So I changed the water inlet solenoid assuming it got stuck. Ofcourse after the overflow... Read more
Screw-washer assembly secures panels and brackets in your washer dryer combo. Replace if worn, missing, or stripped to restore secure fastening.