Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Ordered an new Control board here. Killed gas and power supply. Pulled oven. Opened rear bottom panel. Labeled all wires to control board with “new” locations using electrical tape. Included instructions were great! Pulled all cables. Removed old and reinstalled new control board. Attached all wires to new locations. Tested... Success! Better than ever. Board replacement time - 3 hours total. Time to clean oven back to new... 3 days. Saved us $2k for a service repair or $7k to replace the unit.... Read more
The Jet Holder is an OEM part for Bosch ranges. It is responsible for securely housing components that generate flames and distribute heat across the cooktop surface. The jet holder ensures proper airflow and fuel ignition during operation.
Symptoms of a bad jet holder include:
Causes of a bad jet holder can include cracks developing from excessive heat cycling or debris buildup restricting gas/airflow. Mineral deposits may also cause fittings to warp and lead to improper alignment.
This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
First and foremost, don't believe everything you see on Youtube. In order to get to the gas solenoid that feeds the burner you MUST take the entire top off that side of the range. Remove the grates and burner tops. You will see 2x 20mm brass nut, or so it appears, that hold each burner in place on the splash/drip pan. It is not just a nut, it is a venturi that threads down into what is called the jet holder. You may get a socket on it and think you are getting it loose but, more than likely you... Read more
Usually ships within 4 - 14 days
The temperature sensor is an electronic probe that monitors internal appliance temperature and reports it to the control so it can regulate operation. Replacing a failed sensor restores more accurate temperatures and can clear temperature-related error codes. What it does:
Replaced the bake element. The manufacturer did not leave enough wire to pull the connections into the oven so I had to open the back and locate the connections. Read more
The Surface Burner Holder is an OEM part for Bosch ranges and cooktops. It serves to securely mount and support both the surface burner assembly and gas orifices in place on the cooktop.
Causes of a faulty or damaged burner and orifice holder can include wear from heavy daily cooking demands, broken mounting tabs due to impact or dropped cookware, or corrosion affecting the burner and orifice fittings over many years.
Symptoms of failure include:
This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.
I had to open it up which creates more problems. Opening caused the gas line to break which this gas valve was needed. Read more
The Ignition Device is an OEM part for Bosch ranges and ovens. Located near each gas burner, the ignition device provides the critical spark needed to light the burners during startup.
Causes of a bad ignition device can include wear from prolonged use over many years. Mineral buildup or debris accumulation may also prevent the spark from jumping across.
Symptoms of a bad ignition device include:
First I checked both spark igniters (range has two ovens) by testing them on the oven that did work. Both were good. I then checked the spark igniter wiring & it was good. At this point I contacted Appliance Parts Pros to ask which spark module I should order, the problem was that there wasn't a model number on the appliance. After speaking to the rep I ordered the ignition devise pictured above. Installed it and it worked! Read more