Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
I replaced the broken drive belt first and noticed the drive pulley loose. The nut that had held it in place had backed off. This resulted in significant wear on the pulley hub. I just tightened it up and installed the belt. I noticed the belt had a tendency to change its position on the pulley depending on the direction of rotation. I was a bit concerned but decided to see what would happen. This fix lasted for about a week. The belt came off the pulley and broken again. I called a... Read more
A replacement adjustable leveling leg that supports and stabilizes the appliance and helps restore even height for proper door alignment and stable operation. Use this leg when a worn, bent, missing or damaged leg causes rocking, tilting or uneven gaps. What it does:
I replaced the door seal for the leak. We had a small tear in the sealing surface that resulted in water dripping down the front of the machine (just below the door). I also replaced the detergent dispenser main box with diverter unit. This corrected excessive water being left inside the detergent dispenser at the end of each cycle. I highly recommend replacing the dispenser seal and gasket nozzle to be on the safe side. As these parts are subject to wear and fatigue over the life of the... Read more
It started with problems to power on, then the soil level would changed when you'd move the spin speed and finally it didn't power on again. After reading Q&A it was clear the main board was the problem. So I bought a new one, followed the instructions on the video (very helpful) and that was it!! Read more
We were able to determine the part that we needed with the excellent detailed diagrams offered on this website. Part came quickly. Thank you for your help! Read more
Used a multimeter to determine whether the motor or inverter was bad (Got Error 54 in service mode), which usually means bad motor or inverter. Switchboard was spiking power to the inverter (could hear faint clicking, and the multimeter spiked readings when testing the inverter's terminals from the switchboard, and the motor's wires all checked out with proper ohmage. Heard from other customers that inverter dying was the most likely situation. Bought this new inverter (it looks different than... Read more