Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Rubber bushing that cushions and protects wires from sharp edges inside your washer. Replace if cracked, worn, or missing to prevent wire damage.
Usually ships within 4 - 14 days
Concrete counterweight that attaches to the washer tub to stabilize the drum during spin cycles. Replace if cracked, broken, or missing pieces.
Mounting screw for dishwashers and washers. Used to secure internal components like pumps or transmissions. Replace if stripped, missing, or broken.
Silicon controlled rectifier (SCR) for washer power control boards. Replace if component is burnt, damaged, or failing to regulate current properly.
Replace your washer's housing cover if the original is cracked, broken, or missing. This protective cover installs on the exterior to shield internal components.
Left apron bracket for washers. Secures the apron panel to the washer cabinet. Replace if cracked, broken, or missing to restore proper panel support.
Right side apron bracket for washers. Secures the apron panel to the washer cabinet. Replace if cracked, bent, or broken to restore proper panel support.
Washer leg and platform assembly that supports and levels your washer. Replace if the leg is cracked, broken, or the platform is damaged or missing.
This 1/4-20 screw secures the leg and platform assembly in your top-load washer. Replace missing or loose screws to restore proper balance.
OK kids, pay attention! This was my second attempt @ this repair. My first repair started leaking right away and had to be re-done about 6 months later. HERE IS THE PROBLEM!. In the video, you'll notice that (while putting it back together) when you put the square hole washer and split-ring over the shaft, they look to land atop the rubber seal, buy when you do this in real life, there is a gap between the seal and the washer. (This gap was close to a 1/4 inch). I THINK that the first time I... Read more
Replacement mounting screw for refrigerator components. Installs to secure panels, brackets, or internal parts. Needed when screws are stripped or missing.
White right-hand console endcap for dryers. Replaces cracked, broken, or missing endcaps to restore the finished look of your control panel.
Replacement end cap for washer left-side assembly. Secures cabinet alignment and protects internal components. Needed when original is cracked or missing.
Self-leveling bracket for top-load washers. Mounts to the base to stabilize the unit. Replace if broken, bent, or missing to restore proper leveling.
Insulation wrap that fits around the washer water inlet valve to reduce noise and vibration. Replace if torn, compressed, or missing for quiet operation.
Outer tub cover kit for washers. Includes bleach funnel, clamps, wire tie, and cap. Replace if cracked, broken, or missing components after repair work.
I looked up causes on the internet.I decided what parts I needed then found them on AppliancePartsPros.com. Their videos on how to replace their parts were very good, and customer service was great. My washer is running good now. Read more
Fix a washer that won't spin or agitates weakly with this motor and clutch kit. Solves pulsing motors and failed spin cycles. DIY repair takes 2-3 hours.
Handy Husband took off front of washing machine, unbolted motor then I held motor in place while he bolted on new one.He had to connect new wire harness.One wire was different color..orange instead of white with red stripe.He wrapped old hanging wires to steel bar supporting drum and new wire harness attached to inside where original used to be.He put on the new belt as well since old one was a bit old.He needed a phillips, metric tools..sockets, wrenches, wire cutters,a crimper, pliers and it... Read more