Wfe54ohoeso Parts

This wire harness is the appliance's main electrical connector assembly that routes power and signals between components, restoring reliable electrical connections for controls and motors. Use it to replace a damaged, burnt, or broken harness. What it does:

• Carries power and control signals between the appliance's control board, motors, switches, and sensors
• Replaces damaged wiring that can cause intermittent operation, non-responsive controls, or failure to start
• Restores proper connector fit and secure splices to prevent arcing and poor contact
• Helps eliminate issues caused by frayed insulation, broken terminals, or melted wires

• One complete wire harness assembly

• Disconnect the appliance from power (unplug or switch off breaker) before starting any repair
• Compare the new harness to the old one for connector type and routing before disconnecting components
• Route wires along the original paths and secure with existing clips or ties to avoid heat and pinch points

This oven cavity insulation panel helps reduce heat loss and improves temperature stability inside the oven for more even cooking. It replaces worn or damaged insulation that can allow heat to escape or make the exterior hotter than normal. What it does:

• Provides thermal barrier between the oven cavity and outer cabinet to help maintain internal temperature
• Reduces heat transfer that can cause the exterior surfaces to become unusually hot
• Helps prevent excessive heat loss that can affect cooking performance and energy use
• Fits behind the oven liner where original insulation is mounted

• One oven cavity insulation panel

• Disconnect power (and gas, if applicable) before starting any repair
• Handle insulation with gloves; avoid compressing or tearing the material
• Follow the appliance service manual for proper placement and secure mounting

This right-side slide drawer supports and guides the refrigerator/freezer drawer so it opens and closes smoothly, restoring proper alignment and operation. Simple replacement can stop sagging, sticking, or noisy drawer movement. What it does

• Replaces a worn or broken right-side drawer slide to restore smooth sliding and proper alignment
• Helps prevent the drawer from falling, sticking, or binding when opening or closing
• Supports drawer weight and ensures even movement along the rail
• Works with the existing left-side slide and drawer assembly to maintain fit and seal

• One right-side slide drawer

• Disconnect power to the appliance or remove food and secure contents before service
• Remove the drawer per your model's service instructions to access and replace the slide
• Retain original fasteners and match orientation (right-side) during reassembly
• If you encounter damaged mounting clips or screws, replace them before finishing reassembly

This spacer maintains the designed clearance between parts in your appliance, keeping components aligned for smooth, quiet operation. Replacing a worn or missing spacer helps prevent rubbing, binding, and premature wear in the affected assembly.

• Maintains the correct gap and alignment within the assembly
• Reduces friction, noise, and wear between adjacent parts
• Helps components seat and move smoothly as designed
• Typical symptoms include scraping noises, looseness or wobble, misalignment, or visible spacer damage

• Disconnect power (and water supply, if applicable) before servicing
• Refer to your model's parts diagram to determine the spacer's location, orientation, and stack order
• Reuse existing hardware (washers, clips, screws) as required by your model
• Tighten fasteners snugly without deforming the spacer; verify smooth movement before full reassembly

This spacer provides a precise gap for proper alignment and clearance between components, helping maintain correct part positioning for reliable operation. It's a simple replacement that restores intended spacing and reduces wear. What it does:

• Positions and separates adjoining parts to maintain correct clearance
• Helps prevent rubbing, misalignment, or binding of moving components
• Restores factory spacing after maintenance or part replacement
• Fits where the original spacer was used to support assembly alignment

• One spacer as shown

• Inspect surrounding components and mounting surfaces for damage before installing
• Remove power to the appliance and follow manufacturer service instructions
• Install in the same orientation as the original spacer and verify proper clearance
• If fasteners or adjacent parts are worn, replace them to ensure a secure fit

Color: Black. For white use 9758491

Color: White  Note: Right side endcap