Wfr2460 Uc82/1 Parts

This rear tub section replaces the back portion of the dishwasher tub to restore proper water containment and support internal components. It helps stop leaks and restore the washer's ability to circulate and drain normally. What it does:

• Replaces the rear section of the dishwasher tub that houses and supports internal components
• Restores a sealed tub to prevent water leaks from the rear area
• Helps resolve symptoms such as water pooling, leaks at the back, or unusual noises from the tub area
• Works with existing mounting points and seals to maintain correct alignment of pumps and spray assemblies

• One tub at rear section

• Use correct tools and follow the manufacturer's service manual; remove power and water supply before servicing
• Inspect and replace any worn gaskets or fasteners when installing to ensure a watertight fit
• Tighten fasteners to manufacturer guidelines and verify alignment of pumps/spray arms before testing
• If you notice corrosion or damage to adjacent components, replace those parts as needed to prevent future leaks

This tee adapter connects water lines at the appliance inlet, letting the supply be split or routed where needed for proper water flow. Durable molded fitting designed to match OEM inlet connections and maintain a secure seal. What it does

• Joins or splits the appliance water inlet to accept two hoses or a hose and valve, restoring proper water routing.
• Helps fix symptoms like leaking at the inlet connection, loose hose fit, or interrupted water supply to the appliance.
• Fits into the inlet assembly to maintain a sealed water path and prevent drips when installed correctly.
• Works with compatible inlet fittings and hoses that match the OEM connection style.

• One tee adapter (water inlet) as shown

• Turn off water supply and unplug the appliance before attempting installation.
• Inspect hose ends and seals; replace damaged hoses or O-rings to ensure a watertight connection.
• Hand-start all fittings, then tighten securely—do not over-tighten plastic fittings to avoid cracking.

This small plastic push-on cap covers and protects exposed shafts or fasteners to restore a finished appearance and prevent debris buildup. Fits specific Bosch appliance locations where a cosmetic protective cover is required. What it does:

• Covers exposed shafts, posts, or screw heads to prevent dirt and snagging
• Restores the appliance's finished look after part replacement or repair
• Helps keep moisture and debris out of small openings around mounting points
• Simple, non-mechanical part—no electrical or moving components

• Push the cap onto the matching shaft, post, or fastener until it seats firmly
• Use gentle pressure to avoid deforming the cap; do not force onto mismatched sizes
• Disconnect power to the appliance before accessing internal panels or fastener areas
• Replace only with the correct cap size for the specific location to ensure a secure fit

This wire harness connects the dishwasher flow meter to the main control so the appliance can monitor water flow for proper cycles. Replaces a damaged or corroded harness to restore reliable sensor communication. What it does:

• Transfers electrical signals between the flow meter and the control board so water flow is detected correctly
• Restores communication if a frayed or broken wire causes intermittent or no flow readings
• Helps resolve symptoms such as flow-related error codes, cycles that won't start, or poor wash performance
• Prevents shorts or open circuits that can occur from damaged insulation or connector corrosion

• One wire harness for the flow meter

• Disconnect power and water supply before attempting replacement; follow manufacturer safety instructions
• Inspect the flow meter connector and routing path; replace any clips or fasteners that are broken
• Ensure connectors are fully seated and routed away from moving parts or sharp edges