Whirlpool Wed9400sw0 Parts

This exhaust pipe directs heated air from the dryer drum to the household vent, restoring proper airflow for efficient drying and reduced lint buildup. It's a direct-fit replacement designed to match the OEM airflow path. What it does:

• Channels dryer exhaust from the appliance to the external vent to maintain proper airflow.
• Helps prevent lint accumulation in the cabinet by providing a sealed exhaust path.
• Can reduce long dry times and overheating caused by restricted or damaged venting.
• Addresses symptoms such as poor drying performance, hot dryer cabinet, or noticeable burning/overheating smells near the dryer vent area.

• One exhaust pipe.

• Disconnect power (and gas, if applicable) before starting work; the appliance is fully de-energized.
• Wear gloves to avoid sharp edges; remove old pipe and clean vent connections before installing the replacement.
• Secure with appropriate clamps or fasteners and ensure a continuous, unobstructed path to the exterior vent.
• After installation, run a short cycle to check for leaks.

This replacement plug seals a drain or access opening to prevent leaks and keep refrigerant/condensate and debris where they belong. Fits service openings on compatible Whirlpool appliances to restore a watertight seal. What it does:

• Seals a drain, access hole, or service opening to stop water or debris from leaking out
• Helps maintain proper condensate routing and prevents pooling inside the cabinet
• Prevents pests and dust from entering through unused openings
• Simple, non-electrical part that restores the original seal and function

• One plug

• Disconnect power to the appliance before servicing; follow all safety procedures
• Press the plug firmly into the opening until fully seated; use hand pressure only unless otherwise specified
• Inspect for proper sealing and test with a small water flow before reassembling the appliance

This electronic control board is intended for use with dryers. This component is an interior part protected by other components of the dryer. The electronic control board is the part that ensures all of the other components are working correctly. It manages the parts and controls the temperature and cycle time of the dryer. The most common sign that the electronic control board has gone bad is a dryer that refuses to start. However, it can also cause the dryer to stop heating, continue a cycle endlessly, or cause start and stop behavior. To replace this part, a screwdriver and nut wrench will be required. Shut off the power before removing the top panel to access the electronic control board. Use the screwdriver to remove it so the new part can be installed. Reconnect the wires in the appropriate locations, reinstall the dryer panel, and restore power before using the appliance.Designed for use with Kenmore and Whirlpool dryers, this part is sold as a single item. It is an authentic replacement part that has been sourced directly from the manufacturer.

Includes Center and right side board.

Kit contains total of 8 screws. Approximate size - (Qty.4) #10-32 x 7/16" and (Qty.4) #10-24 x 7/16".