Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Mounting screw for dishwashers and washers. Used to secure internal components like pumps or transmissions. Replace if stripped, missing, or broken.
Usually ships within 4 - 14 days
Fix washer overfilling and water spilling over the tub with this pressure switch. Simple 3-wire installation stops overflow issues. DIY-friendly repair.
I followed the rubber tubing attached to the outside of the washer tub and it was attached to the pressure switch. The switch is the only component in the system that could potentially fail, so I guessed that it had to be the culprit. I ordered the new one, it arrived in less than 36 hours, installed it, plugged the wires in just like the old one (only three wires) and voila, it now shuts off the water flow just like a new washer. Read more
Replace your washer's housing cover if the original is cracked, broken, or missing. This protective cover installs on the exterior to shield internal components.
Washer leg and platform assembly that supports and levels your washer. Replace if the leg is cracked, broken, or the platform is damaged or missing.
This 1/4-20 screw secures the leg and platform assembly in your top-load washer. Replace missing or loose screws to restore proper balance.
OK kids, pay attention! This was my second attempt @ this repair. My first repair started leaking right away and had to be re-done about 6 months later. HERE IS THE PROBLEM!. In the video, you'll notice that (while putting it back together) when you put the square hole washer and split-ring over the shaft, they look to land atop the rubber seal, buy when you do this in real life, there is a gap between the seal and the washer. (This gap was close to a 1/4 inch). I THINK that the first time I... Read more
Replacement mounting screw for refrigerator components. Installs to secure panels, brackets, or internal parts. Needed when screws are stripped or missing.
White right-hand console endcap for dryers. Replaces cracked, broken, or missing endcaps to restore the finished look of your control panel.
Black right-hand side endcap for dryers. Replace this cosmetic trim piece when cracked, broken, or missing to restore the finished appearance of your unit.
Self-leveling bracket for top-load washers. Mounts to the base to stabilize the unit. Replace if broken, bent, or missing to restore proper leveling.
Fix a washer that won't spin or agitates weakly with this motor and clutch kit. Solves pulsing motors and failed spin cycles. DIY repair takes 2-3 hours.
Handy Husband took off front of washing machine, unbolted motor then I held motor in place while he bolted on new one.He had to connect new wire harness.One wire was different color..orange instead of white with red stripe.He wrapped old hanging wires to steel bar supporting drum and new wire harness attached to inside where original used to be.He put on the new belt as well since old one was a bit old.He needed a phillips, metric tools..sockets, wrenches, wire cutters,a crimper, pliers and it... Read more
Fix washer speed control issues or error codes with this VSD inverter board. Controls motor speed and performance. Moderate difficulty repair.
Fix unresponsive touchpad buttons and cycle controls with this washer electronic control board. Restores display feedback and normal operation. DIY repair.
Bushing that supports the washer lid hinge mechanism. Replace if cracked, worn, or causing the lid to sag or close improperly. Direct fit part.
Conduit hose for top-load washers. Protects wiring connections inside the cabinet. Replace if cracked, split, or damaged to restore proper coverage.
White left-hand side endcap for dryers. Replace this structural part if your original is cracked, broken, or missing to restore proper cabinet closure.
Left-hand endcap for dryer cabinets. Replaces cracked, broken, or missing endcaps on the side panel. Ensures a complete finished appearance.